anko RM384.00 Small Hollywood Mirror Instruction Manual
- June 5, 2024
- Anko
Table of Contents
Small Hollywood Mirror
Always
read the instructions carefully before using.
Made in China
Safety Instructions
Do not immerse the appliance in water, Clean the appliance surface with a dry
cloth
If a product becomes damaged, dispose of it as electrical waste according to
local, state, and federal requirements. Repairs should not be attempted.
This appliance has a lithium battery. Do not place or store the appliance for
long periods of time in a hot or humid environment
If you do not intend to use the appliance for a long time, store the appliance
after is fully charged
The light source of this luminaire is not replaceable; when the light source
reaches its end of life the whole luminaire shall be replaced
This appliance contains batteries that are non-replaceable
Caution
- After long storage or first use, press the power switch if no light, please charge 20mins and press the power switch, the mirror can light up
- Continue power ON 1 hour, if there is no action on the switch, the appliance turns into dark model for energy saving , if press any switch again, the appliance stop energy saving model
- In order to save energy and longer battery lifetime, please switch off if the end use
- Once the appliance turns flicker and presses the switch, no any change, the power is low please charge the mirror immediately
Special Feature
This lighted makeup mirror uses Lifetime Energy Saving LED bulbs. Replacement
bulbs are not required
Brightness adjusting switch
Selectable warm, cool, and daylight
Tightening the screw, the mirror turns into the free angle
USB charging is more environmentally friendly
What’s in the box
| |
---|---|---
LED makeup mirror
x
0| LED makeup mirror
x
0| Product Instruction manual
x
0
Product Specification
| Charging Voltage/Current | Type of Battery |
|---|---|
| DC5V/2A | Li-polymer 3.7V 4000mAh |
How to use the mirror
|
---|---
|
|
|
The mirror is powered by 4000mAh li-polymer battery, please make sure it is fully charged| Put your fingers on the power switch on the mirror base, the mirror will be lighted up.
Keep your finger on the power switch stay 1-3 seconds, you can adjust the light brightness as per your needs.| Put your fingers on the light button to switch between warm, cool, and daylight.
Touch the power switch again, the lights will be turned off
How to charge the mirror
- Full charging the appliance with a Type-C USB cable before first use
- Insert USB Type-C into the end of the appliance USB port
- Connect the Type-C USB port with a 5V 2A power supply
- When we start charging, the indicator is in Red. When the mirror is charged full, the indicator will be in Green
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>