JVC GG-01 Gaming Headphone Instruction Manual
- June 3, 2024
- JVC
Table of Contents
JVC GG-01 Gaming Headphone
GAMING HEADPHONES
WARNING
Hearing Comfort and Well-Being
-
Do not play your personal audio at a high volume. Hearing experts advise against continuous extended play.
-
If you experience a ringing in your ears, reduce volume or discontinue use.
Traffic Safety -
Do not use while operating a motorized vehicle. It may create a traffic hazard and is illegal in many areas.
-
You should use extreme caution or temporarily discontinue use in potentially hazardous situations.
-
Do not turn up the volume so high that you cannot hear sound around you.
**CAUTION**
For your safety…
- In dryer air conditions such as in winter, you may feel some static shock when using the headphones.
- Should you start to feel ill while using the headphones, you should stop using them immediately.
- Be sure that your hair or any other objects do not get caught in the headband slider (adjuster) when adjusting the headband.
Avoid using the headphones…
- in places subject to excessive humidity or dust
- in places subject to extremely high (over 40 °C or 104 °F) or low (under 5 °C or 41 °F) temperatures
DO NOT leave the headphones…
- exposed to direct sunlight
- near a heater
To protect the headphones, DO NOT…
- allow them to get wet
- shake them or drop them against hard objects
Precautions for use
- Be careful not to apply power that exceeds the headphones’ input capacity. This may result in sound distortion and could damage the oscillation board.
- Grasp and pull the headphone plug directly when disconnecting from your device. Do not pull out by the cord.
- The ear pads will wear out earlier than the other parts even in normal use or in normal storage due to the material characteristics.
- For replacement of the ear pads, consult with the dealer where you purchased the headphones.
|
---|---
- Be sure to connect the detachable cable in the order of headphone ( ➊ ) and the other device ( ➋ )
- Be sure to connect the detachable cable in the order of Y-splitter cable ( ➋ ), headphone ( ➊ ) and the other device ( ➌ )
Adjust the slider position to fit the ear pads to your ears.
Bend the arm of the microphone to adjust the microphone position
Pressing the mute button ( ) turns on or off the microphone
- When the button is pressed down, the microphone is turned on. When the button is not pressed down, the microphone is turned off (muted).
The serial number can be found by removing the ear pad on the L side
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>