SOUND PRO SPS-3000 Dual Solar Bluetooth True Wireless Speakers User Guide
- June 5, 2024
- SOUND PRO
Table of Contents
QUICK SET-UP GUIDE
SPS-3000 Dual Solar Bluetooth°
True Wireless Speakers
SPEAKERS MUST BE FULLY CHARGED PRIOR TO FIRST USE
CHARGE SPEAKERS
- Remove the speakers and Y-style USB cable from the box.
- Set the speakers near an electrical socket and remove the small rubber covers.
- Plug each end of the micro-USB Y cable into the socket on each speaker. Then plug the single USB end into the AC adapter and insert it into the electrical socket. When the Red LED light goes off on the speakers they are charged and ready to operate. This may take a few hours.
CONNECT TWS
- Push the power button on both speakers and power them on.
- Speakers enter TWS pairing mode and attempt to pair automatically. You will hear an announcement: “Left Channel” and “Right Channel” confirming. If this doesn’t happen go to the back of the Master speaker and push the pair button to attempt TWS pairing again
- Place the speakers in your yard with the Speaker Solar Panels unobstructed from the sun. Speakers should be no further apart than 50′ or reduced Bluetooth operation can occur.
CONNECT BLUETOOTH®
- Push the power button on both speakers and power them on. Speakers will enter Bluetooth Pairing Mode automatically once powered on. You will hear Bluetooth® Mode.
- To connect a device for the first time, go to your device’s Bluetooth® setup and go to the device listed as SOUND PRO SPS 3000. The LED on your speaker will be blinking Blue and you will hear “Bluetooth® Connected” the LED will turn solid Blue when your device successfully pairs with the Master Speaker and announce Connected.
- Select and play music
- Adjust the volume from your device.
READ THE ENTIRE USER MANUAL FOR A COMPLETE UNDERSTANDING OF THE PRODUCTS OPERATION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>