tp-link P125 Tapo Mini Smart Wi-Fi Plug or Socket User Guide
- June 5, 2024
- tp-link
Table of Contents
tp-link P125 Tapo Mini Smart Wi-Fi Plug or Socket
Getting Started
- Get the Tapo app from the Apple App Store or Google Play
- Follow the instructions in the Tapo app to complete the setup.
tapo app
Supported Load Types for US Version
- 125V,50/60Hz, 15A, General use/Resistive
- 125V, 50/60Hz, 1/6HP, Motor load
- 125V, 50/60Hz, 8A, Incandescent
Support
For technical support, the user guide and other information, visit
https://www.tapo.com/support/ or simply scan the QR code.
FCC Statement
This equipment has been tested and found to comply with the limíts for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. Inis equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures.
- increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/IV technician to help
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an
uncontrolled environment and it also complies with Part 15 of the FCC RF
Rules. This equipment must be installed and operated in accordance with
provided instructions and the antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other antenna
or transmitter. End-users and installers must be provided with antenna
installation instructions and consider removing the no-collocation statement.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the users authority to operate the equipment