Faria 305945 Digital Hourmeter Instruction Manual
- June 5, 2024
- Faria
Table of Contents
Installation Instructions
Digital Hourmeter
305945 Digital Hourmeter
CAUTION: Disconnect the battery during installation. Tighten nuts on the back clamp only slightly more than you can tighten with your fingers. Six inch-pounds of torque is sufficient. Over tightening may result in damage to the instrument and may void your warranty.
- Be certain to use stranded, insulated wire not lighter than 18AWG that is approved for marine use. It is recommended that insulated ring terminals be used on all connections to the hour meter.
- Cut a 2 1/16″ diameter hole in the dash and mount the gauge with the back clamp supplied.
- Connect a wire to the positive (+) stud mount of the hour meter. Connect the opposite end to a 12VDC circuit that is activated by the ignition switch.
- Connect a wire to the negative (-) stud mount of the hour meter. Connect opposite end to the boat’s electrical ground, generally available in several locations at or near the instrument panel.
- Reconnect the battery.
NOTE: The hour meter will run as long as the ignition switch remains in the “on” position. The hour meter draws very little current and will operate from 8 – 32 VDC.
IS0291 ECR 7850 04/2009
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>