Clarke CAX20S Short Axle Stand Instruction Manual

Clarke CAX20S Short Axle Stand

SAFETY WARNINGS

• Read these instructions carefully before use.
• Do not exceed the axle stands maximum load (20 tonnes each stand), The vehicle weight will be stated in the owner’s manual.
• Use only as specified in this manual.
• NEVER let children play in or around a vehicle that is on axle stands.
• ALWAYS make sure that before you work below the vehicle, a responsible person is aware in case of injury or accident.
• Do not use more than one pair of axle stands.
• Replace the warning label if it becomes unreadable.
• Use only on a hard, flat surface, for example, concrete.
• Make sure that you check all the wheels that remain on the ground.
• Make sure that the supported vehicle cannot move.
• Set each axle stand below an appropriate strong point on the vehicle See your vehicle owner’s manual for advice.
• Take care when using the axle stands on a three-wheeled vehicle or trailer.
• Use stands as a matched pair to support one end of a vehicle only.
• For your safety, never attempt to modify these axle stands.

WARNING:

• NEVER WORK UNDER A VEHICLE SUPPORTED ONLY BY A JACK.
• AFTER LIFTING THE VEHICLE, SUPPORT IMMEDIATELY WITH PROPERLY RATED AXLE STANDS.

USING THE AXLE STANDS

WARNING

• BEFORE USE, MAKE SURE THAT THERE IS NO DAMAGE TO ANY PART OF THE AXLE STAND, IF THERE IS, DO NOT USE.
• DO NOT EXCEED THE RATED LOAD OF 20 TONNES PER STAND.
• IT MUST BE ENSURED THAT THE VEHICLE/LOAD IS CAREFULLY LOCATED IN THE CENTRE OF THE AXLE STAND SADDLE.
• FAILURE TO DO THIS CAN RESULT  IN DAMAGE TO THE AXLE STANDS, LOSS OF SUPPORT TO THE LOAD, SERIOUS PERSONAL INJURY OR LOSS OF LIFE.

1. Refer to the vehicle handbook for the correct jacking procedure and location of support points.
2. Raise the vehicle using a suitable lifting jack.

ADJUSTING THE AXLE STAND(S)

1. Raise the column to the required height by rotating the handles while holding the saddle to prevent it from rotating.
2. Turn the handles clockwise (looking from above) to raise the saddle.
3. Position the axle stand under a suitable supporting point. See your vehicle manual for the location.

LOWERING THE VEHICLE

1. Slowly lower the vehicle onto the center of the saddle.

WARNING

• DO NOT LOAD THE STANDS OFF THE CENTRE. FAILURE TO HEED THIS.
• MAY CAUSE DAMAGE, INJURY, OR LOSS OF LIFE.

REMOVING THE AXLE STANDS

1. Use a suitable jack to raise the vehicle clear of the axle stands.
2. Remove stands.
3. Ensure that all tools, equipment, and personnel are clear before carefully lowering the vehicle to the ground.

SPECIFICATION

GUARANTEE

This product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt which will be required as proof of purchase. This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for the purpose for which it was intended. Faulty goods should be returned to their place of purchase, no product can be returned to us without prior permission. This guarantee does not affect your statutory rights.

A SELECTION FROM THE VAST RANGE OF

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>