PHONIC AURRAS 6A Powered Nearfield Studio Monitor User Manual

: June 5, 2024
: PHONIC

Table of Contents

PHONIC AURRAS 6A Powered Nearfield Studio Monitor
IMPORTANT SAFETY INSTRUCTIONS
REAR PANEL
CONNECTIONS
ADJUSTING THE VOLUME/TREBLE
TECHNICAL INFORMATION
- SERVICE AND REPAIR
WARRANTY INFORMATION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PHONIC AURRAS 6A Powered Nearfield Studio Monitor

PHONIC-AURRAS-6A-Powered-Nearfield-Studio-Monitor-

IMPORTANT SAFETY INSTRUCTIONS

Read this instructions-All the safety and operating instructions should be read before this product is operated.
Keep this instructions-The safety and operating instructions should be retained for future reference.
Heed all warnings-All warnings on the appliance and in the operating instructions should be adhered to.
Follow all instructions-All operating and use instructions should be followed.

WARNING!

WARNING -To reduce the risk of fire or electric shock,do not expose this apparatus to rain or moisture..
WARNING-do not cover.
WARNING-only use attachments/accessories specified by the manufacturer.
The WARNING-the plug is the main disconnect device and should be used as such.
WARNING-this active loudspeaker may emit high sound pressure levels.
WARNING-do not listen too close to the active loudspeaker.
WARNING-do not listen for an extended period of time at a high sound pressure level.
WARNING -do not attempt to remove the active loudspeaker chassis,there are no user-serviceable parts.
WARNING-do not plug a guitar into The active loudspeaker.
WARNING-do does not insert body parts or objects into the bass port for risk of injury.
DANGER -of dropping the product.
DANGER -of sharp corners.

MOISTURE AND HUMIDITY

The active loudspeaker should be located in a place free from moisture and water.
Do not use this apparatus near water.Do not expose it to rain or dripping water.Do not splash water on it.

INSTALLATION

Do not install near any heat sources such as radiators, heat registers, stoves,or other apparatus that produce heat.
No naked flame sources.such as lighted candles, should be placed on the active loudspeaker.
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

CONNECTION

Connect the active loudspeaker according to the instructions in the manual.
Connect the active loudspeaker only to the correct mains voltage as shown on the equipment.
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles,and the point where they exit the apparatus.
Use only power cables of the type specified in the operating instructions or as marked on the active loudspeaker.Do not substitute the separate power cable included with this active loudspeaker with any other power supply-use only the power cable provided by the manufacturer.
Unplug this apparatus during lightning storms or when unused for long periods of time.
Do not install in an area that impedes access to the power plug. Disconnecting the power plug is the only way to completely remove power to the product and the plug must be readily accessible at all times.

CLEANING

Clean only with dry cloth.

MAINTENANCE

Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way.
such as power-supply cord or plug is damaged,liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
CAUTION:These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do not perform any servicing unless you are qualified to do so.

REAR PANEL

001. TRS INPUT: USED TO CONNECT BALANCED OR UNBALANCED AUDIO SOURCES.
002. RCA INPUT: USED TO CONNECT UNBALANCED AUDIO SOURCES.
003. XLR INPUT: USED TO CONNECT BALANCED AUDIO SOURCES.
004L VOLUME: ADJUST THE AMPLIFIER VOLUME.
005. TREBLE: ADJUST THE AMPLIFIER TREBLE.
006. POWER JACK.
007. POWER SWITCH.

CONNECTIONS

XLR BALANCED INPUT CONNECTION :
PIN 1: GROUND(SHIELD)
PIN 2:HOT(+)
PIN 3: COLD(-)

BEFORE CONNECTING:
KEEP POWER OFF, FIRST MAKE SURE THE INDICATED VOLTAGE IS THE SAME AS YOUR LOCATION VOLTAGE(115V/230V). DO CONTACT YOUR SUPPLIER TO CHANGE THE VOLTAGE BY REPLACING FUSE AND IF IN NEED.

CONNECTION:
TURN DOWN THE VOLUME, THEN CONNECT THE POWER CORD AND SIGNAL LINE.

TURN ON/OFF:
PRESS THE POWER BUTTON, AT LAST, TO TURN ON THE SPEAKER. PRESS THE POWER BUTTON AT FIRST TO TURN OFF SPEAKER.

TURN ON THE SPEAKER THEN THE KNOB TO NORMAL VOLUME.

ADJUSTING THE VOLUME/TREBLE

001. VOLUME:
ADJUST THE AMPLIFIER VOLUME.
002. TREBLE:
ADJUST THE AMPLIFIER TREBLE.

TECHNICAL INFORMATION

Model	Phonic Aurras 6A	Phonic Aurras 8A

Type

| Powered Nearfield

Studio Monitor

| Powered Nearfield

Studio Monitor

(Watt)

| ****

28W

| ****

36W

Low Frequency Rated Power

(Watt)

| ****

45W

| ****

75W

Input Sensitivity| – 2 dBu| – 2 dBu
HF Contour Control| (-2 dB, -1 dB, FLAT, +1 dB)| (-2 dB, -1 dB, FLAT, +1 dB)

Audio Input

| RCA, Balanced 1/4″ TRS,

Balanced XLR

| RCA, Balanced 1/4″ TRS,

Balanced XLR

SERVICE AND REPAIR

SERVICE AND REPAIR
For replacement parts, service and repairs please contact the Phonic distributor in your country. Phonic does not release service manuals to consumers, and advice users to not attempt any self-repairs, as doing so voids all warranties. You can locate a dealer near you at https://www.phonic.com/index.php/where-to-buy.

WARRANTY INFORMATION

Phonic stands behind every product we make with a no-hassles warranty. Warranty coverage may be extended, depending on your region. Phonic Corporation warrants this product for a minimum of one year from the original date of purchase against defects in material and workmanship under use as instructed by the user’s manual. Phonic, at its option, shall repairor replace the defective unit covered by this warranty. Please retain the dated sales receipt as evidence of the date of purchase. You will need it for any warranty service. No returns or repairs will be accepted without a proper RMA number (return merchandise authorization). In order to keep this warranty in effect, the product must have been handled and used as prescribed in the instructions accompanying this warranty. Any tampering of the product or attempts of self- repair voids all warranty. This warranty does not cover any damage due to accident, misuse, abuse, or negligence. This warranty is valid only if the product was purchased new from an authorized Phonic dealer distributor. For complete warranty policy information please visit http://www.phonic.com/.

CUSTOMER SERVICE AND TECHNICAL SUPPORT
We encourage you to visit our online help at https://www.phonic.com/index.php /sup-port/digital-mixers. There you can find answers to frequently asked questions, tech tips, driver downloads, returns instructions and other helpful information. We make every effort to answer your questions within one business day.