perixx PERIMICE-713 Wireless 2.4 G Ergonomic Vertical Mouse User Manual
- June 5, 2024
- Perixx
Table of Contents
perixx PERIMICE-713 Wireless 2.4 G Ergonomic Vertical Mouse
Product Illustration
Low Battery Indicator:LED keeps flashing
- DPI 800: Flashing once
- DPI 1200 (Default): Flashing twice
- DPI 1600: Flashing thrice
Important Safety Instructions:
- Avoid dropping.
- Do not disassemble.
- This product is suitable for moderate climates only.
- The maximum ambient temperature during use of this product must not exceed 40 degree
- Open flame sources, such as candles, must not be placed on this product.
- Only use a dry cloth or brush to clean this product.
Perixx offers a one-year limited warranty with an optional one-year extension.
Specification
| Interface | 2.4GHz | 7 | |
|---|---|---|---|
| Size | 1207663mm | DPI | 800/1200/1600 |
| Weight | 102±5g | 10G | |
| Input current | 3V/6mA | Tracking speed | 30IPS |
| Report rate | 125Hz | ||
| Material | ABS | Durability | 1 million keypresses |
requirements
| Win 7 or later| |
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE 1:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2
Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.