Shenzhen Smart Tech Security WDWA-01 WiFi Door Window Alarm User Manual
- June 5, 2024
- Shenzhen Smart Tech Security
Table of Contents
Smart Tech Security WDWA-01 WiFi Door Window Alarm
User Manual
Specification
Installation
Install the battery
-
Slide off the battery cover
-
Insert 2 pcs AAA batteries correctly as marked
-
The picture below is the correct installation
-
insert 2 pcs AAA batteries correctly as marked**
** -
The picture below is the correct installation
****
Connect APP
- **Download the APP
|
---|---
https://smartapp.tuya.com/tuyasmart|
https://smartapp.tuya.com/smartlife
Scan the QR code to download the APP.
10S: Download the “Tuya Smart” or “Smart Life” at APP Store
Android: Download the ‘Tuya Smart” or “Smart Life at Google Play
-
Register/login to Tuya Smart
-
Network With mobile phone
7. Observe whether
the LED light
flashes quickly, if it is not flashing quickly, please press and hold again for 5 seconds
Maintenance
Replace the batteries Battery lower power warning: When the battery power
is lower than 20%, the APP will warn that the battery needs to be replaced.
Slide off the battery cover
Use a screwdriver to take out the battery from the side
Specification
Working voltage: DC3V (LRO3AAA2)
Static current: 30uA
Transmitting current. 35mA
Working environment: -10t – +50C
WiFi: IEEE 802 11 b 2.46Hz
Alarm output: Low battery warning, water level alarm
FCC Warning:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there s no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator and your body.