SM Tek Group LD3 Shoe Safety Light Clips 3 Mode LED User Manual
- June 5, 2024
- SM Tek Group
Table of Contents
SM Tek Group LD3 Shoe Safety Light Clips 3 Mode LED
INTRODUCTION
These are the coolest shoe accessories you could have. No more
having to buy sketchers just to have light up shoes. Now any
pair of your shoes can glow. Put them on your Jordans! Put
them on your work boots! You could use them with flip flops!
It just might hurt a bit but anything is possible!
PACKAGE CONTENTS
2x Shoe Light Clips
HOW TO USE
- Open Package and make sure both shoe clips are inside their bubble wrap bags
- Just take them out of the bag and slap them on the back of your shoe by the ankle
- Press the power button and watch each step glow
Product Overview
SPECIFICATIONS& FEATURES
Product is 3.5in tall and 2.5 inches wide
The light strip is approx.25in thick around
There is two different light modes – No strobe and Strobe
The studs allow this to be clipped to any shoe
Tight grip will ensure that it doesnt fall off while running
CARE AND SAFETY
- Do not use this unit for anything other than its intended use.
- Keep the unit away from heat source, direct sunlight, humidity, water or any other liquid.
- Do not expose the device to extremely high or low temperatures, as it may damage the battery.
- Do not operate the unit if it has been wet or moist to prevent against electric shock and/or injury to yourself and damage to the unit.
- Do not use the unit if it has been dropped or damaged in any way.
- Repairs to electrical equipment should only be performed by a qualified electrician. Improper repairs may place the user at serious risk.
- Keep the unit out of reach of children.
- This unit is not a toy.
BATTERY DISPOSAL
This product contains a lithium polymer battery. Lithium polymer batteries are environmentally safe when fully discharged. Please refer to your local and state laws for battery disposal procedures.
SM TEK GROUP INC, All rights reserved.
BlueStone is a trademark of SM TEK GROUP INC.
New York, NY 10001
www.smtekgroup.com