Shenzhen Yaohui Technology LK206 Wireless Charging Station User Manual
- June 5, 2024
- Shenzhen Yaohui Technology
Table of Contents
Shenzhen Yaohui Technology LK206 Wireless Charging Station
Diagram
Indicator light description:
Remarks This product only has a working indicator for charging the mobile phone and an indicator for the TWS.
- When the power is on, the green light is on for 3 seconds and goes out
- Standby state: light off
- Charging status: the green light is always on
- FOD foreign body protection on mobile phone: the green light flashes
- Fully charged the green light is always on
Product Specifications:
| Product name | wireless charging station |
|---|---|
| Model | LK206 |
| Input | 5V=2A 9V=2A 12V=1.5A |
| Output | 5W 7.5W 10W |
| Interface Type | Type-C |
Correct Disposal Of This Product
Waste Electrical Electronic Equipment
This Marking shown on the product or its literature. indicate that it should
not be disposed with other household wastes at the end of its working life.
To prevent possible harm to the environment or human health from uncontrolled
waste disposal please separate this from other types of wastes and recycle it
responsibly to promote the sustainable reuse of material resources. Household
user should contact either the retailer where they purchased this product, or
their local government office, for details of where and how they can take this
item for environmental!y safe recycling Business users should contact their
supplier and check the terms and conditions of the purchase contact. This
product should not be mixed with other commercial wastes for disposal.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference,and(2)this device must accept any interference received,
including interference that may cause undesired operation_
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions.may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co –
located for operating in conjunction with any other antenna or transmitter.
This product is a stable and reliable cradle wireless charger.
Compatible with Qi 5W protocol , compatible with Samsung 1 OW protocol ,
compatible with Apple 7.5W protocol.
FQA:
If you’re experiencing interrupted or slow charging.check the following:
- The back of your phone should not have any metal,pop sockets, or credit cards,
- Put the phone in the center of the charging surface(this lets the charging coil in your phone line up with the one inside the wire!ess charger).
- Toe wireless charging coil on Sony phones is located slightly below center.
- Phone cases should be no thicker than 5mm for effective charging,
- Check whether the adapter is OC3 O/OC2 0 fast charger,
If you’re failing to charge your device,please try out the following:
- Please restart your cell phone and test with other USB cable.
- Please check whether the indicator turns on or not.
- Please check the Adapter is QC3.0/QC2.0 or not, iPhone original adapter does not match the wireless charger.
- Please check your Phone case thickness( <=5mm). Metal ring or Magnetic Pad will not be available.
If you’re using the recommended wireless charger with the QC3.0/QC2.0 Adapter and have removed any potential charging obstructions, but are still experiencing issues.try:
- Replacing the cable connecting the wireless charger
- Rebooting your phone.
- Unplug the adapter and reinsert.
Wireless Charger’s Compatible Phone Models and TWS Models:
Works flawlessly with virtually any Qi-enabled phone, Support Apple 2/3/pro,
Samsung headset Samsung Galaxy Buds, Buds+, Buds Pro, Buds Live and other
compatible earbuds with wireless charging case.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>