Lucci decor 269674 Welles 2 Light Floor Lamp Instruction Manual

: June 5, 2024
: Lucci decor

Table of Contents

Installation Instructions
Warranty
Installation Requirements
Installation Directions
Installation Instructions

Installation Instructions

WELLES 2 LIGHT FLOOR LAMP
SKU# 269674
Rated Voltage 220-240V~ 50Hz

Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all instructions carefully before assembly, installation and use of this product. Please keep the instructions for future reference.

Warranty

This portable luminaire is covered by a 12-month warranty valid for in-store replacement or refund only.
The warranty period starts from the date of purchase. Please retain the proof of purchase.
Warranty will be void if there is any damage due to improper usage or modification to the portable luminaire.
Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void the warranty.

Installation Requirements

Select a suitable location for this portable luminaire:
– Ensure it is on a flat and stable surface.
– This portable luminaire is suitable for indoor use only.
– Do not place flammable material near or over the portable luminaire.
– Ensure the portable luminaire is not installed in the direct line of an air vent/system.
– If the portable luminaire is placed in an area prone to moisture, ensure that the area is well ventilated, and an appropriately rated exhaust fan is used if required. Damage or corrosion caused by moisture is not a product fault, and as such is not covered under warranty.
Do not exceed the maximum wattage rating.
Take care not to pull any electrical wires during unpacking as this may damage the connection.
Lay out all the components on a smooth surface and make sure no components are missing before assembling. If parts are missing, return the complete product to the place of purchase for inspection or replacement.
Check whether the luminaire has been damaged during transport. Do not operate/install any product which appears damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
Do not plug into the mains power socket-outlet before or during assembly. Only do so after the portable luminaire is fully assembled with the globe installed and is ready to use for the first time.

Installation Directions

Remove all packaging material from the portable luminaire. Place the luminaire on a smooth non-scratch surface to help with assembly.
Attach the bottom rod (G) onto the base (H), followed by the middle rod (F), top rod (E) and then the top part of the luminaire (C).
NOTE: Pull the cord out from the base (H) as you assemble to remove any slack or tension on the cord. Take care not to cross-thread the rods or twist and damage the cord during assembly.
Install the cover (L) onto the luminaire base (H).
Install globes (D – not included) into the lamp holders. Do not exceed the maximum wattage rating.
Install the shade (B) onto the centre rod and secure with the finial (A).
Select a suitable location for the portable luminaire. See the installation requirements above.
Insert the plug (J) into the mains power socket outlet and ensure it is fully plugged in.
Turn the power on at the mains power socket outlet.
Use the cord line foot switch (I) to turn the portable luminaire on/off.

Installation Instructions

Safety Tips

Always ensure the power is OFF and the portable luminaire has cooled down before performing any maintenance, cleaning, changing the globes or making any adjustment to the portable luminaire.
The external flexible cable or cord of this luminaire cannot be replaced; if the cable or cord is damaged, the luminaire shall be destroyed.
Young children should be supervised to ensure that they do not play with the portable luminaire.
Handle the portable luminaire and shade with care to avoid any damage or breakage.
Select a suitable location away from liquids and hazards.
To clean, wipe with a soft damp cloth. Do NOT soak or immerse the product in water or other liquids.
Ensure that the fitting does not come in contact with corrosive chemicals/solvents or abrasive cleaners etc.