UNDER ARMOUR UAFP03 Shoe Device User Manual
- June 4, 2024
- Under Armour
Table of Contents
UNDER ARMOUR UAFP03 Shoe Device
FEATURES
- Small, robust, and encapsulated
- Low-cost and disposable
- Lowest energy consumption available – active and sleep modes – with long battery lifetime
- Custom firmware loaded at production
- Secure over-the-air updates possible with all major mobile platforms
- Support of Bluetooth low energy standard and custom profiles
- Non-volatile memory for data logs
DESCRIPTION
- UAFP03 is a high-performance Bluetooth low energy pod with advanced algorithms to analyze athletic performance and optimized for use in “smart” shoes.
- The small and robust UAFP03 comes fully encapsulated for reliable use in harsh environmental conditions. The pod has been optimized for low-cost and is recyclable.
- The UAFP03 can be used to implement efficient and low- energy algorithms for various walking and running metrics such as step-counting, cadence, speed, etc. When not in use, the pod dissipates minimal energy.
- UAFP03 is shipped pre-programmed with custom firmware and can be securely updated in the field with over-the-air programming from a mobile device (all major iOS® and AndroidTM devices supported).
- A reprogrammable non-volatile memory is provided for storage of logs until downloaded to a mobile device.
USE
- Get 1 POD from the incoming black tray, do visual check.
- No damaged on POD.
- POD information should be clear.
- If the POD get damaged/QR code unclear, put in NG tray.
- Put POD into test box.
- The black side facing up.
- Close and lock the machine, use “Test station 3” program for testing.
- OK à Mark P on the POD, put in OK tray .
- NG à Put in original black tray from right to left.
- After finish 1st round inspection, then start to inspect NG POD again.(2nd Inspection)
- After 2nd inspection, If still NG should “mark the error code” on QC sticker and stick to
- blue side of POD (Reference on Error Code Library) and put in NG tray .
- Note : If error code is 1, 2, 8, please take out Bluegiga dongle then plug in again (as the picture shown) and re-test the POD. If re-test result ok ,mark “ü” on the POD , put in OK tray .
- Put sole on POD wake up holder-rotating (1à8), toe downward, wait for 5 sec, max 5 min.
- Note:
- Make sure there is no sole unit on POD wake up holder-rotating during break time and the end of the day.
- Put sole unit on test box. Note:
- Sole Unit’s lateral against alignment rail.
- Close and lock the machine, use “Test station 4” program for testing.
- OK à Stamp “Pass “ and Transfer to next process.
- NG à Put sole back in original holder-rotating number.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>