AZEADA PD-BT118 Wireless Earbuds User Manual
- June 3, 2024
- AZEADA
Table of Contents
PD-BT118 Wireless Earbuds
User Manual
Product Information
- Wireless Version 5.0
- Charging Time: <130mins
- Earbuds Battery: 30mAh
- Charging Box Battery: 180mAh
- Charging Port. Type-C
- Speaker Size: 13MM
- Operation Method: Touch Control
- Working time: about 7.84
- Transmission distance. 10M
- Ta[kinging Time:120 days
Controls
- 0pen the changing. case, waiting for automatic painting Switch Bluetooth function on the phone, search and click device pg118″4¢ pairing
- Singe touch of power button Pause/lay
- Double touch of power button Volume /+
- Triple touch of the power button Previous/Net song
- With a long press of the power button Spirit another voice assistant)
- A long press of the power button4er I0s Power olt
- Automatic pairing once successfully Connected
Earphone operation instructions
Power On — Hake out the earbuds from the charging box./2.A long touch over 2s
if the earbuds are powered off.
Power Of —
-
Put the earbuds back into the charging box./2.A long touch over 4s if powered is on. (It can not be powered off while connecting with the phone)
Pair with Smart Phone — Being taken out of the earbuds from the charging box the 1st time, the left and right earbuds will pair to each other automatically and start to connect with another device. -
Two earbuds will automatically connect to the previous device once taken out from the charging box.
-
If just take one earbud out of the box, it will start to connect with the previous bud or phone. If no device-related is a connected device, it will start single pairing mode.
Disconnected — If the distance is over the effective range, the earbuds
will be disconnected and try to connect again. If not successfully connected
within 3 ms, it will be powered off.
Disconnected — If manually disconnected, the earbuds will start to
connect automatically.
Power off under low voltage — Earbuds will be powered off if the voltage
is under 3.1V
Charging — Earbuds start to charge once put back in the charging box.
Answer call — Single touch to answer the call
End call — Single touch to end the call
Reject call — Long touch over 2s to reject the call.
Charge the charging box — Red light will flash while charging and always
be on once
Charge the earbuds — Green light will be on once the earbuds are put in
the charging box. Greenlight will be off once the charging finishes.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment