AZEADA AZ-BT01 Yonle TWS Wireless Earbuds Instruction Manual
- October 30, 2023
- AZEADA
Table of Contents
AZ-BT01 Yonle TWS Wireless Earbuds
Instruction Manual
Product Information
Model:—————– AZ-BTO1
Wireless version:———– 5.3
Distance:——————— 10m
Speaker size:————– 13mm
Earphone capacity:——————–35mAh
Charging box capacity:—————250mAH
Using time:——————————— 5H
Controls
- Open the charging case, waiting for automatic pairing Switch function on the phone, seach and click device ” AZ-BT01″ for pairing
- Single touch of power button: Pause/Play
- Double touch of power button: Volume -/+
- Triple touch of power button: Previous/Next song
- Long press of power button: Siri( other voice assistant)
- Long press of power button(over 10s): Power off
- Automatic pairing once successfully connected
Earphone operation instructions
Power On —
-
Take out the earbuds from the charging box./2.Long touch over 2s if the earbuds are power off. Power Of — 1.Put the earbuds back to the charging box./2.Long touch over 4s if power on.
(It can not be power off while connecting with the phone)
Pair with Smart Phone — Being taken out of the earbuds from the charging box the 1st time, left and right earbuds will pair to each other automatically and start to connect with other device. -
Two earbuds will automatically connect to previous device once being taken out from the charging box.
-
If just take one earbud out of the box, it will start to connect with previous bud or phone. If no device related connected device, it will start single pairing mode.
Disconnected — If the distance over effective range, the earbuds will be disconnected and try to connect again. If not successfully connected within 3 ms, it will be power off.
Disconnected — If manually disconnected, the earbuds will start to connect automatically.
Power off under low volatage Earbuds will be power off if voltage is under 3.1V
Charging— Earbuds start to charging once put back in the charging box.
Answer call — Single touch to answer the call
End call — Single touch to end the call
Reject call — Long touch over 2s to reject the call.
Charge the charging box Red light will falsh while charging and always be on once
Charge the earbuds — Green light will be on once earbuds are put in the charging box. Green light will be off once charging finish.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with pad 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
