RC Jumping Car Instructions 207030

: June 2, 2024
: Sharper Image

Table of Contents

JUMPING CAR

JUMPING CAR

RECHARGEABLE BATTERY WARNING

• There is a risk of fire and personal injury if battery is punctured, damaged, or misused
• Do not dismantle, crush, incinerate or short-circuit battery.
• Never expose battery to extreme temperatures or moisture
• Keep away from flammable materials and direct sunlight
• Only charge using the provided charger, cable, and/or adapters
• Rechargeable battery is only to be charged by an adult.
• Adult Supervision of the battery while it is charging is required
• Allow battery to cool to room temperature before charging.
• Charge on a non-flammable surface and keep away from flammable products
• Discontinue charging if battery becomes hot, swells, smokes, or gives a strong odor.
• Battery chargers used with the product are to be regularly examined for damage to
the cord, plug, enclosure, and other parts, and in the event of such damage, they
must not be used until the damage has been repaired.
• Remove batteries before storing
• Recycle or dispose of battery according to federal, state, and local laws
• Keep these instructions for future reference.

BATTERY WARNING

• Do not mix old and new batteries
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries
• Alkaline batteries are recommended. Use only the specified voltage.
• Insert batteries using the correct polarity. Always use, replace, and recharge (if applicable) batteries under adult supervision
• Do not charge with non-rechargeable batteries
• Do not short-circuit the battery supply terminals
• Do not dispose of batteries in fire, batteries may explode or leak.
• Remove batteries before storing.
• Recycle or dispose of batteries according to federal, state, and local laws.
• Keep these instructions for future reference.

BATTERIES AND CHARGING

The remote control requires 2 “AAA 1.5V alkaline batteries (not included).
REMOTE CONTROL:
• Use a Phillips head or Cross screwdriver to open the battery compartment at
the base of the remote.
• Insert the AAA 1.5V batteries according to the diagram inside the battery tray.
• Replace battery cover and tighten screw.
CAR:
• The charging port is located on the underside of the vehicle.
• ONLY use the included USB cable.
• Useable with standard 5V USB port or charger

SAFETY PRECAUTIONS

• Avoid water when operating.
• Do not submerge car or controller in water.
• Do not use people or animals as obstacles.
• Do not run car into furniture objects or hard surfaces as this will cause damage to both the objects and car.
• Keep fingers, hair and loose clothing away from the tires, gears and motor while car is switched to “ON’.
• Do not leave car or transmitter near sources of heat or under direct sunlight for long periods of time.
• Remove all batteries when not in use to avoid accidental operation.
• Adult supervision is recommended when operating car.
• Thoroughly inspect products before every use. If the product appears worn, frayed/splintered, cracked, or broken in any manner, discontinue use and discard immediately.

Warning

KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT INFORMATION FOR FUTURE REFERENCE.
Due to continuous product improvements, the picture on the manual may differ slightly from the actual product.

2-Modes-Insert-Comment

Power-Switch

Jumping-Mechanism

USAGE

• Turn both the vehicle ON by pressing the button under the vehicle
• The remote will automatically pair to the vehicle
• Press the Joystick and the front remote buttons to navigate
• Make sure there are no obstacles within a 3-foot range (above or around the vehicle) then press the rear Jump Button to make the car jump.