Groove and Go Bluetooth Alarm Clock User Manual

: June 2, 2024
: Groove and Go

Groove and Go Bluetooth Alarm Clock

Thank you for choosing the Groove and Go Bluetooth Alarm Clock.
Please read all instructions carefully before use.

Important Safety Instructions

Read these instructions
Keep these instructions
Heed all warnings
Follow all instructions
Do not attempt to open or repair the unit by yourself
Loud sound can be unhealthy, adjust accordingly
Handle waste packaging, batteries, and electronics according to law
regulations
Do not place the unit close to heat sources or under direct sun light
Do not place the unit in the vicinity of electrical or magnetic fields
Handle the unit with care and avoid impact
Do not use this apparatus near water
Clean only with dry cloth
Do not block any ventilation opening. Install in accordance with the manufacturer’s instructions
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat
Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong the wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult and electrician for replacement of the obsolete outlet
Protect the power cord from being walked on or pinched particular at plugs, convenience receptacles, and the point where they exit from the apparatus Only use attachments/accessories specified by the manufacturer
Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
Unplug this apparatus during lightning storms or when unused for long periods of time.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally or has been dropped

Technical Informatio

Bluetooth version: 2.1+EDR
Stereo audio play
Bluetooth range: >30ft
Output power: 3W+3W
Distortion: <10%
SNR:>70dB
Audio frequency response: 100Hz-20KHz
FM radio frequency range: 87.0MHz-108.0MHz
Audio input: Bluetooth, TF card, AUX, FM
Adjustment type: Manually on unit & by remote control
Power supply: 5V 2A adaptor

Bluetooth speaker features

Bluetooth hands free function
MP3 play: play music directly from TF card
Audio input: Easily connected to computer, digital player, mobile phone, mobile device
Sleep timer: sleep time range 5-90 minutes
Charger: Charge mobile phone or other mobile device Via USB port

Functions description

Clock calendar

LCD screen displays year, month, day, hour, minute
Calendar setting default time is TUE. 0:00,1 January 2013
Available setting time is from 1 January 1980 to 31 December 2099

Two sets of alarm/snooze function

Alarm can be set as BB sound or song from TF card or FM radio music
Alarm duration: 3 minutes
Snooze duration: 5 minutes
Snooze repeats: unlimited

TF card play function

TF card slot can support capacity of 32MB~32GB
Support TF card in MP3 and WMA formats
Digital volume level range is 1~32, (default volume level is 20)
With MP3 snooze function, snooze time is up to 90 minutes

FM digital frequency display

FM frequency range: (87.0~108.0) MHz, tuned in increments of 100KHz
Digital volume level is 1~32, (default volume level is 20)
Automatic and manually frequency search
Radio sleep timer: 5-90 minutes

LINE IN/AUX

Digital volume level is 1~32, (the default volume level is 20)
Support AUX sleeping, sleep time 5-90 minutes

Infrared remote control function

Support 0~9 digital keys, combinations, 1~9999
Support frequency search

LED backlight

LED backlight will be off within 2 minutes
To turn Backlight on press on the remote control

Keys description

MODE key

Switch between clock and calendar displaying and alarm setting
Enter to clock setting mode or alarm setting mode by holding down for
2 seconds

Forward Key

In Bluetooth mode, force pairing mode by holding down for 5 seconds
In play mode, short press for play or pause function
Answer an incoming call by short press
Refuse an incoming call by holding down for 2 seconds
When alarm sounds, press the key to enter alarm snooze mode

Reverse/Volume Down key

Short press for previous song
Hold for volume adjustment
In volume adjustment mode – Short press for decreasing 1 unit of volume level
In FM mode – Press key to search for previous radio station

Forward/Volume UP Key

Short press for next song
Hold for volume adjustment
In volume adjustment mode – Short press, for increasing 1 unit of volume level
In FM mode – Press key to search for next radio station

INPUT Key

Switching audio mode: Bluetooth mode, TF card mode, FM radio mode,
LINE IN/AUX mode
Sleep shutdown mode: when playing song, hold for setting snooze time

Clock Key

Turn on & off alarm 1 or alarm 2
In TF card mode or FM radio mode hold to set the playing song or FM station
as alarm

Operation instructions

Clock mode

Press MODE key to enter clock mode
Hold MODE key for 2 seconds to enter clock setting mode
Short press the MODE key for time setting, setting order: 12/24 HR, hour, minute, year, month, day
To set hour, minute, year, month, day: press Reverse/Volume Down to adjust down and press Forward/Volume Up to adjust up
To advance through each setting press the MODE key (setting order:12/24 HR, hour, minute, year, month, day)
Day will automatically adjust according to date and month.

Alarm mode

Press MODE key to enter alarm 1 or alarm 2 mode
Hold MODE key for 2 seconds to enter alarm setting mode, short press MODE key to adjust alarm time (hour and minutes), alarm types (BB,TF,FM) and end up setting.
When setting AL1/AL2 alarms, press Clock key to turn on or off.
– – – indicates; alarm off, alarm time indicates alarm is on set
In the alarm setting status – press Forward/Volume Up / Reverse/Volume Down key to choose beeps sound, TF card or FM music as an alarm sound
Setting TF card as an alarm: in the TF card mode, hold Clock key- for 2 seconds, then LCD display “SET AL1” with flashing, set the playing song as an alarm, then press Forward/Volume Up / Reverse/Volume Down key to choose between alarm 1 or alarm 2; if no operation within 3 seconds, it will automatically return to playing mode, as shown in the picture below:
Alarm time must be set before setting desired FM station as alarm sound
FM wake up setting: in the FM mode, choose the station, hold Clock key for 2
seconds, display will flash “AL1” press Forward/Volume Up / Reverse/Volume Down key to choose alarm 1 or alarm 2; if no operation within 3 seconds is selected, it will automatically return to playing mode, as shown below:
Press the MODE key to set AL1 or AL2. Radios will turn off and alarm is set to selected station and current volume level
In alarm time setting status, it will return to time display mode if no button is
pressed within 10 seconds
When alarm 1 is turned on, it displays time on alarm 1; when alarm 2 is turned
on, it displays time on alarm 2; When both alarm 1 and alarm 2 are turned on
at the same time, alarm 1 and alarm 2 alternately display every 10 seconds.
Turn off snooze function: under snooze status, turn off snooze function by
pressing any key, but do not execute the key function
Snooze function: when alarm sounds, switch on snooze function by short
press Forward key, snooze mark will be displayed and LED backlight panel will be
bright, snooze time is 5 minutes (no snooze function in FM radio alarm)

Bluetooth pairing connection

In the Bluetooth mode, long press Forward key for 5 seconds to force entering pairing searching mode, the Bluetooth mark will flash on the LCD screen, at this time, speaker has already entered pairing searching status:
Turn on Bluetooth speaker, and searching – Example for mobile phone: on the Bluetooth searching menu, it will display “PBTeen Clock”. Then click it to connect, when it is connected, speaker has a sound indication. At this time, the Bluetooth mark on the LCD screen stops flashing and stays lit, there is a pause sign above the Bluetooth mark.
Press INPUT key to enter Bluetooth mode, it automatically opens to pair
and re-connect with 60 seconds

Playing mode selection

Press INPUT key to switch Bluetooth mode, TF card mode, FM radio mode or AUX mode (LINE IN mode)

Bluetooth hands free function

When mobile phone connects to speaker via Bluetooth, incoming call will sound by the speaker and a phone icon will be displayed
Short press Forward key to receive an incoming call, speak to caller through the microphone on the speaker. Phone icon will be displayed, when call is ended, music will come back
Long press Forward key for 2 seconds to refuse a call
When making a call, short press Forward key to end the call

Music playing

Bluetooth setting

Please refer to above paring method.
After connection, play music from mobile device, and enjoy the music
press Forward key for pause and press again to continue, watch the corresponding mark on the LCD screen.
Short press Reverse/Volume Down key for previous song, long press Forward/Volume Up to decrease volume level; short press key for next song, long press to increase volume level.

TF card setting

Insert TF card into card slot, it automatically enters TF card mode and plays music (except during the phone call status)
Short press Forward key for pause and press again to continue, watch the corresponding mark on the LCD screen
Short press Reverse/Volume Down key for previous song, long press to decrease volume level; short press Forward/Volume Up key for next song, long press to increase volume level.

FM radio setting

Unfold the back antenna, place the speaker at a strong signal area.
Short press INPUT key to enter FM radio mode Reverse/Volume Down key to search previous station, long press it to decrease volume level, short press Forward/Volume Up key to search for next station, long press it to increase volume level
Under searching status, LCD screen displays radio frequency

AUX / LINE IN

Insert 3.5mm audio cable into AUX IN port Bluetooth alarm clock, short press INPUT key to enter AUX mode (LINE IN mode)
Connect your device to other end of 3.5 mm audio cable
To control song selection you must use your device controls
Short press Forward key to pause and press again to continue
Long press Reverse/Volume Down key to decrease volume level, long press Forward/Volume Up to Increase volume level.

Sleep (SLP) setting

In the Bluetooth mode, TF card, AUX or FM radio, press INPUT key for two seconds to enter SLP mode, press Reverse/Volume Down / Forward/Volume Up key to adjust SLP time value, adjustment range: OFF,5,10,15,20,25,30,35,40,45,50,55,60,65,70,75,80,85,90.
If no key is pressed within 3 seconds, it will automatically confirm SLP time and return to the original mode, or short press (INPUT )key to return to original mode
SLP mark and SLP time mark each lights alternately for 2 seconds

Remote Control Introduction

MODE corresponds to MODE key;
INPUT corresponds to INPUT key
Backlight corresponds to key
corresponds to key
corresponds to
corresponds to
corresponds to
previous song or radio search
corresponds to next song or radio search
Number keys 0~9

In the TF card mode: input the corresponding song number, if exist, it will play the song, song numbers are available from 1~9999: In the FM mode, input the station number, watch the screen for display confirmation.
Choose any station between 87.0~108.0MHz

Charging switch function

To charge mobile device: Connect USB cable to USB port and connect your device to other end of USB cable.

Groove and Go Bluetooth Alarm Clock User Manual – Optimized PDF
Groove and Go Bluetooth Alarm Clock User Manual – Original PDF

Read User Manual Online (PDF format)

Read User Manual Online (PDF format) >>

Download This Manual (PDF format)

Download this manual >>