HOMCOM 370-170V90 6 V Kids Ride on Cars Electric ATV Toy Instruction Manual
- June 1, 2024
- HOMCOM
Table of Contents
IN230200128V02
370-170V70_370-170V90
370-170V90 6 V Kids Ride on Cars Electric ATV Toy
Installation and Operation Instructions
Forward and backward operations by manual shift
Techniques of volume regulation and MP3 amplification function
Battery power display
*Suitable for children of 3-5 years old. Oe) C 4*
Max weight: 30 kg.**
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
ASSEMBLY INSTRUCTION
Product Specifications :
Battery: 12V/10AH
Drive Motor: 12V 5502 (10000RPM)
Suitable age : 37-60 months
Maximum weight: 30kg
Car Size: 10365*73cm
Speed: 3-8km/h
Hours of Use: Using 1-2 hours after Charging 8-10hours
Charger: Input: 100V-240V
Output: 12V1A
Analytic Graph
Function
Function indication
(1) USB
(2) TF
(3) MP3
(4) The voltage display
(5) Multi-Media| (6) Light Switch
(7) Speed Switch
(8) Forward Stop Back
(9) Power Switch
---|---
-
Install the Steering Rod and Front Axle
Turn the body over, bottom up. There are 11 screws in front axle mounting and steering lever holding position. Remove them with a screwdriver. Pierce the steering rod into the fixing hole and lock the fixing part with 3 screws. Install the front axle assembly in alignment, lock and fix it with 8 screws.
-
Install the shock absorbers
-
Install the rear wheels
Remove the nuts and gaskets on the rear axle, pass the rear axle through the motor assembly. Install the rear wheel, gasket and nut on the left and right sides of the rear axle and tighten with wrench. Fit the wheel cover into the hole in the wheel.
-
Install the front wheels
Remove the nuts and gaskets on the front axle, install the front wheel, gasket and nut on front axle and tighten with wrench. Fit the wheel cover into the hole in the wheel. Install the front wheel on the other side in the same way.
-
Install the dashboard
Connect the two cables of the dashboard to the body, and then align the dashboard to the position on the body and clamp it.
-
Install the handlebar
First, remove the screw and nut from the handlebar connector, insert the handlebar connector into the steering rod, pass the screw through the fixing hole and lock the nut.
-
Connect the power cord
First remove the seat, Plug the power cord port on the battery tightly as shown in the figure, and turn on theca’s power supply to test whether the connection is successful.
-
Install the backrest
Align the backrest with the hole on the body and fix it.
-
Install the front box
First remove the four screws on the front cover, align the front frame with the hole, and fix
WARNING
Only adults can install parts and adjust the car, keep moving parts out of
children’s reach.
Children under 36 months cannot use the toy car asith as many small parts.
Children must keep the car away from the fire.
Children can use the product only in the company of adults, and the adult
should not leave during the process.
Never let Children stand or play onto the pedal or in the car.
Only adults can complete storage battery charging, and must charge the product
before it’s first use. Keep such package materials as plastic bags out of
children, or they will suffocate or kill children.
Never use parts provided by non-manufacturers. Never let children play with
the charger.
The number of connected power by the product can never be over the recommended
number.
Notice of use:
Not to be used in traffic.
Never use the product in such dangerous zones as street, road, slope or drain.
Never change the circuit and additional electric devices.
Never use remote control in rainy days or in the water, never pour water or
other liquid into the car, keep the product out of the fire, otherwise the car
will be damaged,
Only one child can use the product and it’s weight cannot exceed 30KGS.
Turn off the power when not in use and remove battery connector when not using
it for a long time.
As the product has battery charger, check whether wire plug shell and other
parts are damaged or not, and fix those damaged parts.
The product must be assembled by the adult!
Before assembling, screws and pins are dangerous sharp points.
Charging steps are as follows:
Step 1: The charging hole is under the steering wheel
Step 2: Put the charger plug into the plug hole.
Step 3: Connect the charger to the power socket.
Warning: Car must be charged by
adults only. Car is useless during charging.
Trouble Clearing
| Type | Analysis | Solutions |
|---|---|---|
| The car cannot get started. | Low battery voltage; |
Protection of electric devices;
Failure to press the switch button correctly;
Falling of power connector;
Battery breakdown;
Damage of electric devices;
Generator breakdown;| Charge battery fully;
Use the car a few minutes later;
Use the car according to instructions;
Install the connector again;
Change battery;
Change electric devices;
Change generator.
The battery cannot be charged.| Falling of battery connector;
No charging for the charger;
Charger breakdown;| Install the connector again;
Plug the charger again;
Change the charger.
The car has a short range.| Not full charging of battery;
Much-used battery;| Charge fully the battery again;
Change the battery.
There appear slight noise and heat of the car in charging.| Chemical
reactions;| Normal reactions
The car has a slow speed| Much-used battery;
No electricity for battery; Overload;
Uneven driving surface;| Change the battery
Charge fully the battery again
Reduce the load below 30 kilograms
Drive on uneven surface
Charging notice
Charge storage battery less than 10 hours, or the storage battery will be
damaged for ever.
In charging, put DC Plug into the power socket , put charger into power plug;
never use the product during charging it.
The product can be used for one hour and the charging time is 8-10 hours,
exceeding no more than 18 hours.
It is common for charger and storage battery to have not become heated
(temperature under 60 degrees)in charging.
Never use the connector with the water, or short circuit will happen.
Use the product’s own charger, otherwise it will cause damage to the charger
and battery or short circuit.
Charge the product when not using it for a long time.
Maintenance and service
Before use children’s parents should check whether charger’s wiring, plug,
shell and other parts are damaged, and fix those damaged parts.
After using the product for a time, parents should lubricate iron castings
with lube, or those castings will get rusted; they should keep the product out
of fire and lay it flat in dark places; they should put the product inside the
house or cover it with one water-proof cloth in wet whether.
Parents should keep the product out of such hot objects as stove and heater,
or its plastic parts may be thawed; they should keep the product out of
combustible objects in charging, or the fire may happen.
Parents should clean car surface with one dry cloth, or clean plastic parts
with non-waxy furniture polish; they should not clean plastic parts with
chemical solutions or clean the car with water; children should not drive the
car in wet or rainy weather, or the car’s generator, circuit system and
battery will be damaged.
When not using or laying the product, parents should cut off car power,
keeping all the switches into “STOP” or “OFF” model.
Parents should not use the fuse which doesn’t conform with the agreed
specifications.
Parents should not change product structure and circuit system, and should
have the product checked and fixed by professionals or under the guidance of
professionals.
If you have any questions, please contact our customer care center.
Our contact details are below:
0044-800-240-4004
enquiries@mhstar.co.uk
IMPORTER ADDRESS:
MH STAR UK LTD
Unit 27, Perivale Park,
Horsenden lane South
Perivale, UB6 7RH
MADE IN CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>