PawHut 049V04 Dog Kennel Instruction Manual
- June 1, 2024
- PawHut
Table of Contents
PawHut 049V04 Dog Kennel
INSTRUCTION MANUAL
IMPORTENT:
READ CAREFULLY
WHAT’S IN THE BOX
ASSEMBLY
Repeat this step twice for the top and bottom frames.
Install the chain-link mesh onto the gate frame. Then insert the two round rod into the edges of the chain-link mesh, and then use 4 pairs of hooks to fix the round rods and tube. Finally, use the bind-wire fo fix the chain-ink mesh to the gate frame to make the gate rigid and strong.(Note: loosen the clips on the post to allow adjustment and exact fitment)
Use the door hinges (and the big set of screws) to fix the door to the frame. Then install the security-lock on the dog kennel outdoor. Tie bind wire to fix the top and bottom of the gate with chain-link mesh and make the gate safe and strong by using the screw gun with the drill to put a self-tapping screw through the pilot holes in the tubes-this also makes the dog kennel outdoor stronger.
Installing the chain link mesh
First start by unrolling the compressed chain-link mesh roll on the ground and extending it. Then check whether the mesh wires are misaligned and unhooked, and restore it. Next roll it again. And use ties(L)to fix one side of the mesh on the braided door frame. After that wrap the mesh around the dog kennel. During the process of enclosing, use ties (L)to fix the mesh up and down to prevent it from slipping. After that tighten the mesh and fix it to another doorframe pillar and remove the excess mesh. Finally reinforce and fix with steel wire(K).
Notice
1. Need 2 people at least when you assemble to avoid the damage of steel
tube.
2. Do not use this cage unless all bolts, screws and knobs are firmly secured.
3. Please use it on a flat hard ground.
4. No climbing and no revision on product.
5. Caution, hands pinching.
Warning:
A: Guarantee every post upright
B: Fasten (J) with Rand electric tool in the right direction.
C: Make sure every (J) assembled correctly before put your kennel in use.
If you have any questions, please contact our customer care center.
Our contact details are below:
001-877-644-9366
customerservice@aosom.com
Imported by Aosom LLC
27150 SW Kinsman Rd Wilsonville, OR 97070 USA
MADE IN CHINA
Product Specifications:
-
Model Number: IN240100159V01_GL_D02
-
Country: US_CA
-
Dimensions: 295+1700 x 250+1310 x 1375
-
Weight: 1375
-
Material: Steel
-
Color: Grey
-
-
Frequently Asked Questions (FAQ):
Q: What should I do if some parts are missing?
A: Contact customer service with your order details to request replacement parts.
Q: Can I disassemble the product for storage?
A: Yes, follow the reverse steps of the assembly instructions to disassemble the product for storage.
Q: How do I clean the kennel?
A: Use a mild detergent and water solution to clean the kennel, then dry it thoroughly before use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>