Unitechu RT112 Rugged Tablet User Guide
- June 1, 2024
- Unitechu
Table of Contents
Unitechu RT112 Rugged Tablet
Specifications:
- Model: RT112
- Front Camera: Yes
- Rear Camera: Yes
- Scan Engine: Included
- USB Type-C Connector: Yes
- Trigger Key: Yes
- Power Key: Yes
- Programming Key: Yes
- Pogo Pin: Yes
- Scan Lens: Yes
- Speaker: Yes
- NFC: Yes
- Battery: Included, rechargeable
- LED Indicators: Red, Green, Blue
. Install the Battery:
- Push the bottom battery lock to the left (unlock) and hold it.
- Align the battery with the slot and insert until you hear aCLICK sound.
- Ensure the battery is securely locked in place.
- Align and insert the battery cover, then press down until secure.
Checking LED Status The LED indicators provide important information:
- Red Light: Indicates battery charging or low battery status.
- Green Light: Shows battery fully charged or successful barcode scan.
- Blue Light: Controlled by scanner app if running.
Package
Please make sure the following contents are in the RT112 gift box. If something is missing or damaged, please contact your Unitech representative.\
The Package Contents
- Tablet PC
- Battery Pack
- USB-C Power Adaptor (power cord optional)
- Quick Start Guide
Optional Accessories
- Rotatable Hand Strap
- Shoulder Strap
- Screen Protector
- Capacitive Stylus Pen (5.5mm) with coil strap
- Office Cradle
- Vehicle Cradle
- 3-Pin EU Power Cord
- 3-Pin UK Power Cord
- 3-Pin US Power Cord
Product View
Front Camera- Scan Engine
- Power Key
- Programming Key
- Trigger Key
- USB Type-C Connector
- Trigger Key
- Pogo Pin
- Scan Lens
- Rear Camera
- Speaker
- NFC
- Battery Cover Latch
- Battery Cover
- Volume Key
Install the Battery
-
Push the bottom battery lock to the left (unlock) and hold it, then align the battery with the battery slot and insert until you hear a “CLICK” sound. The battery should not fall off while the battery is being locked.
-
Align the battery cover, insert it into the slot, and then press down on the battery cover.
-
Push the four battery cover latches to the lock position.
Remove the Battery
-
Push the four battery cover latches upwards to the unlock position.
-
Pick the battery cover with a tool from the groove on its side and lift upward to remove.
-
Push the battery lock at the bottom to the left (unlock) and keep holding it, then pull the battery strap and lift upward to remove the battery.
Getting Started
Before starting to use the tablet, we would like to suggest you follow the illustrations below to begin to use the tablet.
WARNING!
There is a risk of fire and burns if the battery is handled improperly. DO NOT
disassemble, crush, puncture, short external contacts, or dispose the battery
pack in fire or water.
DO NOT attempt to open or service the battery.
Dispose used batteries according to local recycling guidelines in your area.
CAUTION!
To ensure the unit working properly, please keep all connectors away from the
contaminants such as dust, grease, mud, and water. Negligence may cause the
unit to lose communication, short circuit, or overheated. If the connector is
damaged, please ensure the connector is fully repaired before using the unit
to avoid short circuit.
DO charge between 20% and 80% to protect your battery.
Avoid full discharges (<0%) or charging all the time (always 100%) to reduce
stress on the battery.
EU Importer:
Unique Technology Europe B.V. Kapitein Hatterasstraat 19, 5015 BB, Tilburg,
the Netherlands
Copyright 2023 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>