Maxx Cold MCR-23FDHC Single Door Commercial Reach in Refrigerator Installation Guide
- June 10, 2024
- MAXX COLD
Table of Contents
Maxx Cold MCR-23FDHC Single Door Commercial Reach in Refrigerator
Installation Guide
INSTALLATION
- GOOD AIR CIRCULATION
- Be sure to avoid any object which will restrict exhausted air flow.
- Be sure that there is ample space so that air can flow through the rear of the unit.
- The back of the unit should be located no less than 5 inches from the wall.
- PLACE ON STRONG GROUND
- Be sure the location chosen has a floor strong enough to support the total weight of the cabinet and contents.
- DO NOT PLACE NEAR HEAT SOURCE
- Be sure to avoid hot corner or location near stove, oven, or other heat source.
- High ambient temperature will make cooling efficiency lower.
- INDOOR USAGE ONLY
- This equipment is intended for indoor use only.
- STABILIZING
- Make sure the unit is installed in a stable condition with the front wheels locked while in use.
- LEVELING
- Be sure that the unit is level from front to back and side to side.
- Unit should be on dedicated electrical circuit.
- Do not use extension cords
- Isolate the unit on an electrical circuit of proper size.
- Place black plastic condensate pan thru back or front. Make sure pads are installed upwards and drain hose is in pan.
- Install the unit where the air circulation is good.
- Maintain enough spaces around the unit since air circulation is very important for the unit cooling performance.
- If air circulation is obstructed, then cooling performance will drop, consuming more electricity as a result.
Reference
- If a door for left hand is necessary, please contact the sales representative in your area.
- A set of door & Door hinge can be purchased separately to convertible between Right Hand and Left Hand side.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>