ARISTON Lydos Hybrid Wifi 80 Liter Electric Thermos User Guide
- June 1, 2024
- Ariston
Table of Contents
ARISTON Lydos Hybrid Wifi 80 Liter Electric Thermos
Quick Start is merely an introductory document and does not replace the manual. Carefully read the manual prior to installing and using the product.
ACCESSORIES
- Supplied: A 1 overpressure device (8 bar) – B 2 dielectric unions size 1/2” – C Condensate drainage pipe – D Y-shaped condensate water connector – E 2 wall plugs, 2 hooks.
- Not supplied: F 1 safety unit (mandatory in EU countries requiring it) – G 2 connection pipes – H Siphon – I Spacer – L Union – M Teflon tape – O Drill – N Spirit level.
INSTALLATION APPROACH
- 80 l model: two people
- 100 l model: two people
INSTALLATION INSTRUCTIONS
PRODUCT POSITIONING
- To ensure correct operation, the room in which the product must be installed must have a volume of at least 13 m3.
- The temperature of the air in the room in which the appliance is installed must be between 10°C and 40°C; if out of range, the product will only operate in heating element mode.
- Observe the minimum installation distances to ensure correct operation and guarantee sufficient room for any maintenance operations.
USING THE INSTALLATION JIG
- The external packaging contains a full-size drawing of the product showing the exact position of the slots and brackets.
FIXING THE APPLIANCE TO THE WALL
- After levelling the jig and marking the holes on the wall, drill the latter using the drill O.
- Insert the wall plugs into the holes, followed by the hooks E. Place the brackets on the hook and make sure that they are properly secured.
DISMANTLING THE SIDE COVERS
- Remove the plastic screw caps
- Remove the screws and the bottom cover
- Detach the side fins
HYDRAULIC AND ELECTRICAL CONNECTION
HYDRAULIC CONNECTION
The water inlet and outlet are marked as follows:
- blue ring for the cold water inlet; red ring for the hot water outlet Apply Teflon tape M to the appliance’s cold and hot water pipes.
Installation in non-EU countries (picture on the left)
- Secure the dielectric unions B
- Install the overpressure device A
- Connect the hoses G
- Screw on the condensate water connector D
Installation in EU countries (picture on the right)
- Secure the dielectric unions B
- Screw the safety unit F onto the cold water pipe
- Connect the hoses G
- Install the union L and the spacer I
- Turn the drainage elbow to connect the condensate drainage pipe C to the spacer I
- Connect the siphon H to the spacer I
Connect the water distribution pipe of the domestic circuit to the hot water pipe. Fill the product until water comes out of the tap.
ELECTRICAL CONNECTIONS
- The product is equipped with a cable and plug, simply connect it to a power supply source.
SOLVING PROBLEMS
- For any clarifications concerning the product or its installation, consult the complete manual or contact the Ariston technical assistance service.
CAUTION: Rigorously observe the general warnings, the applicable installation rules and the instructions specified in the manual.
INFORMATION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>