OSPREY 4x32CB Crossbow Scope Instructions
- June 1, 2024
- OSPREY
Table of Contents
OSPREY 4x32CB Crossbow Scope
BRIEF INTRODUCTION
Riflescopes produced in our factory extensively can be applied to various rifles. It has a crosshair instead of traditional front sight and gap, and this can increase aiming speed, accuracy, and percentage of hits.
INSTRUCTIONS
- SD2.5X20DP
- 3 × 32CB
- 4× 32CB
- SD4 X32MD
- SD6X42MOA
- SD3-9X40S
FEATURES
- Eye Bell
- Lock Ring For Focus
- Magnification Ring
- Upper Handwheel Cover
- Right Handwheel Cover
- Distance Ring
PERFORMANCE PARAMETER TABLE
SPECIFICATIONS FOR OSPREY RIFLE SCOPE
USAGE
Focusing
Look through the scope within a 3 or 4-inch distance from your eye to the
eyepiece lens. If you can’t see the reticle clearly- ly, loosen the knurled
lock ring and rotate the bell until the reticle appears clearest. Then screw
the lock ring to lock the eye bell firmly.
Mounting
The scope is installed on a gun utilizing a mount. Rotate the scope tube so
that the vertical crosshair is vertical and the horizontal crosshair is
horizontal. Adjust the position of the scope on the rifle so that proper eye
relief is achieved. Then tighten all screws to fix the scope on the rifle
firmly.
Boresighting
Aim at a target 100 m away and fire at it. If the impact point deviates from
the aiming point, measure the vertical and horizontal distance between these
two points, Screw off the upper and right handwheel covers of the scope and
turn two handwheels in the direction shown in the table below. Keep on firing
and adjusting untill the impact point coincides with the aiming point
.
CAUTION : One click on the hand wheel equals 1/2 or 1/4 inch displacement on the target I 00 m away(see performance parameter table.)
- Adjusting magnification Magnification of the scope with a magnification adjusting system can be varied by rotating the power ring.
- Adjusting distance Superior riflescope has a distance adjusting device. When shooting at a target, rotate the distance ring to the corresponding position
MAINTENANCE
- Keep scope in the place free from acid, alkaline and other corrosives.
- Dust and dirt on the surface of the scope should be cleaned with a soft cloth or soft tissue with a little alcohol.
- In case of damage, seek help from the company.
RETICLE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>