Shenzhen Yinzhihang Technology Co Ltd 2BFFW-ASG200 ASG200 Wireless Earphones User Manual
- June 1, 2024
- Shenzhen Yinzhihang Technology Co Ltd
Table of Contents
Shenzhen Yinzhihang Technology Co Ltd 2BFFW-ASG200 ASG200 Wireless Earphones
Product Overview
Instructions for use
How to use it for the first time: Turn on the headset – use the wireless function of the mobile phone to find the headset name AS-G200 – perform pairing connection
Multifunctional left button| Long press: switch MP3 mode/ Bluetooth mode|
Click three times: previous song| Click three times: next song
---|---|---|---
Multifunctional right button| Long press: power on/off| |
Click: Voice Assistant| Click: Pause/Play; Answer or hang up the call| |
Double click: Volume-| Double click: volume +; Double-click the call status:
reject the call| |
Headphone specifications
| Music playing time | ≈5 hours |
|---|---|
| Full charging time | ≈2 hours |
| Standby time | ≈7 days |
| Connection distance | 10 m |
| Speaker type | bone conduction |
Kind tips
- Dear user, for you to have a better experience with this product, please fully charge it before use.
- Please use a DC5V charger and a computer to charge the headset. Do not use DC9V, DC12V, or DC24V to charge this headset.
- If this product is left idle for a long time, please charge it once within 2 months to ensure good battery performance.
- After wearing this product for exercise, it is recommended to use a dry towel to clean the sweat and water stains on the surface of the product, and leave it for 2 hours. Make sure that the charging port is dry before charging the earphones to prevent sweat short circuit during the charging process from affecting the service life of this product.
- Listening to music at high volume for a long time may cause discomfort. Please use a medium volume as much as possible and avoid listening at high volume for a long time.
- Do not throw or press the headphones; keep them away from fire and high-voltage equipment.
Made in China
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure statement
The device has been evaluatec to meel general RF exposure requirement. The device can be used in portable exposure condition without restriction.