PHILIPS X3003-02 Wet and Dry Electric Shaver Installation Guide
- June 1, 2024
- Philips
Table of Contents
PHILIPS X3003-02 Wet and Dry Electric Shaver
Specifications
- Brand : Philips
- Compliance : Electromagnetic fields (EMF) standards
- Support: Visit www.philips.com/support for FAQs
- Battery: Built-in rechargeable battery
Product Usage Instructions
Safety Precautions
- Only use the product for its intended purpose.
- Ensure hands, products, and batteries are dry when handling batteries.
- Avoid accidental short-circuiting of batteries after removal.
Battery Removal
- Check for screws in the appliance housing and remove them, if present.
- Continue removing screws, panels, or parts until the rechargeable battery is visible.
- Safely remove the rechargeable battery from the appliance.
Battery Disposal
- Before removing the battery, ensure the appliance is disconnected from the power source.
- Make sure the battery is completely empty before removal.
- A qualified professional should handle battery removal.
- Avoid contact between battery terminals and metal objects.
- Tape battery terminals or place batteries in a plastic bag before disposal.
FAQ
- Q: How do I dispose of the built-in rechargeable battery?
- A : The built-in rechargeable battery should only be removed by a qualified professional. Ensure the appliance is disconnected from the power source, the battery is empty, and follow safety precautions for handling and disposal.
- Q: Where can I find support for this product?
- A: For all product support, including FAQs, visit www.philips.com/support.
Important safety information
Only use the product for its intended purpose. Read this important information carefully before you use the product and its batteries and accessories, and save it for future reference. Misuse can lead to hazards or serious injuries. Accessories supplied may vary for different products.
Warning
- To charge the product, only use a certified safety extra low voltage (SELV) supply unit with an output rating 5 V, ≥ 1 A. For safe charging in a moist environment (e.g. in a bathroom), only use an IPX4 (splash-proof) supply unit. A suitable supply unit (e.g. Philips HQ87) is available via www.philips.com/support. If you need support finding the correct USB supply unit, contact the Consumer Care Center in your country (see the international warranty leaflet for contact details). Using a non-certified supply unit may cause hazards or serious injuries.
- Keep the USB cable, the USB supply unit and the charging stand (if provided) dry (Fig. 1).
- This appliance is waterproof (Fig. 2). It is suitable for use in the bath or shower and for cleaning under the tap. For safety reasons, the appliance can therefore only be used without a cord.
- This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children without supervision.
- Do not modify the supply unit.
- Do not use the supply unit in or near wall sockets that contain an electric air freshener to prevent irreparable damage to the supply unit.
- Do not use a damaged appliance. Replace damaged parts with new Philips parts.
- Because of hygiene, only one person should use the appliance.
- Unplug the appliance before cleaning it with water.
- Only use cold or lukewarm water to clean the appliance.
- Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids to clean the appliance.
- Maximum sound power level: Lc = 69 dB(A)
- Water may drip from the socket at the bottom of the appliance when you rinse it. This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the appliance.
- Only use original Philips accessories or consumables.
- Charge, use and store the product at a temperature between 10 °C and 35 °C.
- Keep products and batteries away from fire and do not expose them to direct sunlight or high temperatures.
- If the product becomes abnormally hot or smelly, changes colour or if charging takes longer than usual, stop using and charging the product and contact Philips.
- Do not place products and their batteries in microwave ovens or on induction cookers.
- Do not open, modify, pierce, damage or dismantle the product or battery to prevent batteries from heating up or releasing toxic or hazardous substances. Do not short-circuit, overcharge or reverse charge batteries. • If batteries are damaged or leaking, avoid contact with the skin or eyes.
- If this occurs, immediately rinse well with water and seek a medical care.
WHAT’S INCLUDE
HOW TO USE
Support
For all product support such as frequently asked questions, please visit
www.philips.com/support.
Recycling
- This symbol means that electrical products and batteries shall not be disposed of with normal household waste (Fig. 3).
- Follow your country’s rules for the separate collection of electrical products and batteries.
Removal of built-in rechargeable battery
- The built-in rechargeable battery must only be removed by a qualified professional when the appliance is discarded. Before removing the battery, make sure that the appliance is disconnected from the wall socket and that the battery is completely empty
- Take any necessary safety precautions when you handle tools to open the appliance and when you dispose of the rechargeable battery.
- When you handle batteries, make sure that your hands, the product and the batteries are dry.
- To avoid accidental short-circuiting of batteries after removal, do not let battery terminals come into contact with metal objects (e.g. coins, hairpins, rings). Do not wrap batteries in aluminium foil. Tape battery terminals or put batteries in a
plastic bag before you discard them
- Check if there are screws in the housing of the appliance. If so, remove them.
- Remove any additional screws, panels or parts of the appliance until you see the printed circuit board with the rechargeable battery.
- Remove the rechargeable battery.
References
Read User Manual Online (PDF format)
Loading......