Libraton 1-4 Copper Tube Bender Instructions
- June 1, 2024
- Libraton
Table of Contents
Libraton 1-4 Copper Tube Bender
Specifications
- Model: XYZ-2000
- Dimensions: 10 x 5 x 3 inches
- Weight: 2 lbs
- Power: 120V AC
- Capacity: 1 liter
Product Information
- The XYZ-2000 is a versatile and user-friendly product designed to simplify your daily tasks. With its compact dimensions and lightweight design, it is easy to handle and store.
- The product operates on standard 120V AC power and has a generous capacity of 1 liter, making it suitable for various applications.
Usage Instructions
Initial Setup
- Before using the XYZ-2000 for the first time, ensure that all components are properly assembled according to the user manual.
- Connect the power cord to a suitable power outlet.
Filling the Tank
To fill the tank, remove the cap located on the top of the product. Pour the desired liquid into the tank up to the maximum fill line indicator. Securely place the cap back on.
Operating the Product
Turn on the product using the power button located on the front panel. Adjust the settings as needed using the control panel. The product will start functioning according to the selected mode.
Maintenance
- After each use, make sure to clean the product thoroughly following the cleaning instructions provided in the user manual.
- Regular maintenance will ensure optimal performance and longevity of the product.
Frequently Asked Questions (FAQ)
Q: Can I use the XYZ-2000 with essential oils?
A: Yes, you can use essential oils with the XYZ-2000. However, make sure to dilute the essential oils as per the recommended guidelines to prevent damage to the product.
Q: Is the XYZ-2000 suitable for continuous operation?
A: The XYZ-2000 is designed for intermittent use. It is recommended to follow the specified usage guidelines to prevent overheating and ensure product longevity.
INSTALLATION INSTRUCTION
O I R is for precision 90° bending
- Measure the distance (X) from the end of the tube (first bend) and place a mark on the tubing.
- Position the tube in bender as shown in Fig. 1. If the end from which you measured is left of the tube clamp, the measured mark should be directly over graduation “L” located on the right side of the form lever and shown in Fig. 1.
- If the end from which you measured is placed to the right clamp, set the mark on the tube directly over graduation “R” located on the form lever and shown in Fig. 2. With a steady motion, pull the form lever handle around until the “o” mark on form handle is directly opposite the 90° mark on form wheel.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>