UNIFORMATION D265 Curing Station 3D Printers User Manual
- June 1, 2024
- UNIFORMATION
Table of Contents
D265 Curing Station
D265 Curing Station Manual
*This user manuat mainly includes product overview, operation instructions, maintenance and troubleshoobng. Please read thoroughly and follow the steps to set up the curing station.
Assemble
1.1 Packing list
| No. | Name | Qty | Unit |
|---|---|---|---|
| 1 | Curing Machine | 1 | Pc |
| 2 | 24V3A Power Adapter | 1 | pc |
| 3 | Acrylic Turntable | 1 | pc |
| 4 | Screw | 1 | pc |
| S | User Manual | 1 | pc |
1.2 Turntable installation
-
Place the turntable an the bearing, the frosted side facing up, and fix it with the screws.
-
Connect power and turn on the machine on the back.
-
Open the tid, put the cleaned and dried model into the station
-
Close the lid, start curing. (you can also set up to 10 minutes)
Product Overview
2.1 Professional curing box
Resin curing is an essential step in resin 3D printing. This process allows
your prints to achieve maximum hardness and stability. A dedicated UV curing
station is great for faster post-processing and getting professional quality
results with minimal effort.
2.2 Product introduction
2.2 Specification
| Machine Technology | LED UV Curing |
|---|---|
| Space for Model | D260 H140mm |
| Compatible for | 3D prints, handicrafts, jewelry, dentistry |
| Timing settings | Digital display setting (default 3 minutes, max 10 minutes) |
| Input | 100-240V |
| Power | 60W |
Timer Setting
Step1: Change minutes & seconds
A) Press icon “setting’, the minutes will flash, which means you can reset the
minutes.
B) Press icon “setting” again, the seconds will flash, then you can reset the
seconds.
Step2: Confirm the setting
Select to start curing, or select again to confirm the time setting.
Precautions for use
4.1 Before use
- Unpack, check whether the accessories are included and make sure there is no damaged or broken.
- Put the curing box on a stable table.
4.2 Safety use
- Do not wipe the equipment lid and other parts with corrosive cleaning liquid, such as alcohol, tiana water, etc.
- Do not move the device when curing the models so as to avoid short circuits or other accidents.
- Do not open the lid when curing the models so as to avoid discomfort caused by strong UV light on the eyes.
https://www.facebook.com/UniformationOfficial
https://www.uniformation3d.com/
Basic Troubleshooting
- If the turntable does not rotate: Please check whether the screw of the turntable is loose, if it is loose, then tighten it.
- The LED fights is on, but the UV light is not on and the turntable does not turn, Check if the flip sensor on the right bezel is working properly.
https://www.facebook.com/groups/661715828314843
https://linktr.ee/Uniformation3dPrinter
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>