Vanbus-02B-MB Cup Washer for Sink User Manual
- May 15, 2024
- Vanbus
Table of Contents
User’s Manual
Vanbus-02B-MB Cup Washer for Sink
Pis Contact Us for More Options
STANDARD ACCESSORIES LIST
| No | Name | Qty |
|---|---|---|
| 9 | Mix Metal Cup Holder | 1 |
| 8 | Brass valve with 10 spraying holes | 1 |
| 7 | 304 Stainless steel plate | 1 |
| 6 | Rubber gasket | 1 |
| 5 | Stainless steel gasket | 1 |
| 4 | ABS Nut | 1 |
| 3 | 3/8 Brass water line adapter | 1 |
| 2 | 304 Stainless steel Waster supply hose | 1 |
| 1 | Installation instruction | 1 |
Check
accessories
Standard List of Accessories:
When you open the product packaging, please check whether the objects in it
are consistent with the main body and accessories you purchased. If there is
any inconsistency, please contact our company or our distributor.
Note:
- Accessories are subject to change without prior notice if the change does not affect usage;
- The appearance of the product is subject to the physical objects you receive, and the schematic diagram is only for reference.
INSTALLATION STEPS
This product has been inspected and debugged by the factory to the best
condition. Please do not disassemble and assemble it yourself. Before
installing the Glass Rinser, please be sure to remove sundries and sludge from
the water pipe to prevent sundries from blocking the Glass Rinser. Helpful
Information Tools:
Gather the necessary tools as shown below to complete the installation of this
Glass rinser.
Easy Installation
STEP1~3
Slide mounting shank through sink from above, then slide the shank through the
rubber washer , then through the steel support washer.
STEP4~5
Ensure base is aligned with sink and outlet extends into basin prior to fully
tightening mounting nut.
STEP6~7
Ensure base is aligned with sink and outlet extends into basin prior to fully
tightening mounting nut.
Determine whether you wish for your new glass rinser to be supplied by cold or
hot water. Unthread existing faucet supply line from angle stop on the chosen
side.
Thread provided tee onto angle stop in place of the supply line that was
disconnected in the previous step. Thread both the faucet supply line and the
3/8″ end of provided supply line to tee.
Thread the 1/2″ end of provided supply line to mounting shank. Wrench may be
used on shank flats to avoid rotation. When supply line is installed, check
alignment and retignten mounting nut.
INSTALLATION DIMENSION
CLEANING CARE
In order to keep the appearance of Glass Rinser clean, bright and good performance, please take care of the Glass Rinser as follows;
- Rinse with water only and dry with soff cotton cloth;
- Use mild liquid and colorless glass cleaner to remove surface dirt and scale fim, or use polish without abrasive effect;
- Do not use abrasive deterfgent, polish, emery cloth, paper towel or scraper, etc.;
- Do not use acid cleaner, or cleaner and soap with insoluble gran etc.;
- In the process of use, mud my accumulate in the bubbler and make the water flow show, The bubbler can be unscrewed, rinsed with water, and then installed back in place.
Pls feel free to contact us if you have any questions. We will solve this in time with this email of vanbus@163.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>