DDUOO 2021 RGB Color Changing Spare Tire Brake Light Instruction Manual
- June 1, 2024
- DDUOO
Table of Contents
DDUOO 2021 RGB Color Changing Spare Tire Brake Light
Specification
Uasge:Spare Tire Wheel Brake Light- Voltage:12v DC
- Color Of Light:Red(Brake Light)+RGB(Running Light)
- Control: RF Control (RGB)
- LEDs:1 S0PCS
- Waterproof:IP67
- Diameter:13.8 lnch(350mmx350mmx23mm)
INSTALLATION
- Step 1 Remove your spare tire using a 19mm socket.
- Step 2: Remove the baffle, as shown in the figure (note that removal from the bottom up, excessive force will cause deformation and fracture of the plastic buckle)
- Step 3: Install the tire light and connect the control box connection terminal to the spare tire lamp terminal through the internal air baffle.
- Step 4: Arrange the plug and pull ii over the right hole
- Step 5: Unplug the upper brake light of the original car and reconnect it with the RGB spare tire light plug
- STEP6 After the brake light function is installed, the next step is to connect the RGB DRL line (red) to the original taillight
- Step 7: Remove the right bracket with metal screws and plastic buckle screws (both to be removed)
- Step 8: After confirming all remova you can pry open the baffle
- Step 9 :Unplug the original taillight
- Step 10: Connect the red DRL harness to the taillight service light wire (blue+ white wire).
- STEP 11: Restore everything that was torn down
- STEP 12: Test work is normal, you can install the equipment tire fixed.
REMOTE CONTROLLER INSTRUCTION
- A: ON/OFF
- B: SPEED +(1 Cleves)
- C: MODE – (TYPES)
- D: AUTO CHANGE MODE (EACH MODE RUNS 4 CYCLES)
- E: MODE + (120TYPES)
- F: BRIGHT-(32leves)
- G: SPEED (101 eves)
- H: BRIGHT+(32leves)
- I: PAIR/UNPAIR
- J: STATIC WHITE
- K: SETTING
- L: STATIC RED
- M: STATIC GREEN
- N: STATIC BLUE
- O: STATIC YELLOW
- P: STATIC CYAN
- Q: STATIC PURPLE
NOTE: IF THE COLOR DOES NOT IUIATCH WITH THE COTROLLER, IT’S BECAUSE OF THE “SETTINGPROBLEM. PLEASE FOLLOW THE STEPS BELOW, AND THE PROBLEM WILL BE SOLVED:
Extension Wiring(52 Inch)
- Take out the plastic sheet, start the Engine, press ON/OFF button, press “SETTING in 3 seconds, and the lamp will turn white, which means get into “SETTING” state;
- In “SETTING” state, press “PAI R/UNPAIR” button, if the spare re Tire flashes red, which means “CODE Mismatching”; press “PAIR/UNPAIR” button again, if the Spare Tire Light flash GREEN, means “CODE Matching”;
- In “SETTING” state, press “R” over and over again, until the Lamp turn red; press “G” over and over again, until the Lamp turn green; then succeed to setting-up RGB Sequence;
- Press the “SETTING” button, exit the “SETTING” state. Attention: must exit “SETTING” state by “SETTING” button, otherwise, the above operations will not be reserved
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>