GLADEN GENERIC 100 Midrange Speaker Instruction Manual
- June 1, 2024
- GLADEN
Table of Contents
GENERIC 100
Safety instructions
Please read all notes and warnings in this manual.
These will not only inform you about possible damage or injury, but also about
possible functions and settings.
Our products are only suitable for users with the necessary specialist
knowledge. The relevant safety regulations for load-bearing body parts,
regulations on internal vehicle safety, as well as the regulations of the
responsible vehicle manufacturers (general operating licence) must be
observed.
Hearing damage: Sustained, excessive volume levels of over 85 dB can
permanently impair hearing. Stereo systems are capable of producing sound
pressure level of over 85 dB.
Sound level and perception: The use of stereo systems can impede the hearing
of important sounds and signals in traffic and thus lead to hazards while
driving. GLADEN assumes no responsibility for hearing damage, physical injury
or property damage resulting from the use or misuse of its products.
Working on vehicles: Do not operate vehicles until all retrofitted components
(speaker boxes, speakers, amplifier, DSP, …) are securely installed. Loose
parts can become dangerous (flying) projectiles in the event of a sudden
driving maneuver or an accident. Do not drill or screw into vehicle panels or
sheet metal until you are sure that there are no important parts, cables or
lines underneath. Pay attention to things like fuel, brake, oil lines and
electrical cables as preparation for installation when planning the system.
Disconnect the earth terminal (-) from the vehicle battery (auxiliary
batteries) before starting installation to avoid possible short circuits. If
body panels are to be machined or removed for mounting the speakers or
amplifiers, contact an appropriate specialist
workshop. In the event of damage to load-bearing bodywork parts, the operating
permit may be invalidated! Be careful when removing interior panels. The
vehicle manufacturers use a wide variety of fastening elements (clips, screws,
rivets, …) which can be damaged or may be damaged during dismantling (dents or
scratches on surfaces (e.g. metal sheets may rust)).
Electricity danger! DO NOT touch the connections of the amplifier or the
speakers during operation!
Electric and hybrid vehicles! There is danger to life! Do not any work on the
electrical system by yourself!
Information on disposal of old electrical and electronic equipment (applicable
for countries that have adopted separate waste collection systems): Products
with the symbol (crossed-out wheeled bin) cannot be disposed of as household
waste. Old electrical and electronic equipment should be recycled at a special
waste facility.
Contact your local authority for details in locating a recycle facility
nearest to you. Proper recycling and waste disposal will help conserve
resources whilst preventing detrimental effects on your health and the
environment.
This product can be disposed of with the used car together. In this case don’t
remove it from the car.
Hereby, GLADEN EUROPE declares that the loudspeaker described herein is in
compliance with Directive 2011/65/EU.
The complete EU Declaration of Conformity is available on the homepage under
the respective www.gladen.com product.
Technical data:
| Fs: | 110 Hz |
|---|---|
| Re: | 2,9 Ohm |
| Z: | 3 Ohm |
| Qms: | 4,23 |
| Qes: | 0,91 |
| Qts: | 0,75 |
| Vas: | 1,55 Liter |
| Sq | 53 qcm |
| Mms: | 5,03 g |
| SPL: | 89 dB (1W/1m) |
| Pe: | 100 |
| Frequency range: | 110 – 12.000 Hz |
| Cut-off frequency: | 250 Hz (18 dB/Oct) |
300 Hz (12 dB/Oct)
400 Hz ( 6 dB/Oct)
Dimensions| Dimensions
A:| 99,3 mm
B:| 90,0 mm
C:| 38,0 mm
D:| 43,5 mm**
** Sicke: 47 mm Surround: 47 mm
Features:
- 100mm midrange driver with an air-dried paper cone, cast aluminum basket and neodymium drive unit
Although we have carefully researched and checked several times, we cannot accept any liability for possible errors.
****Bertha – Benz – Straße 9
72141 Walddorfhäslach
www.gladen.com