GLADEN Z-SUB-RSX-SLIM-ANL RSX SLIM Subwoofer Owner’s Manual
- June 12, 2024
- GLADEN
Table of Contents
RSX
SLIM
Owner´s Manual
Safety Instructions
Please read all notes and warnings in this manual.
These will not only inform you about possible damage or injury, but also about
possible functions and settings.
Our products are only suitable for users with the necessary specialist knowledge. The relevant safety regulations for load-bearing body parts, regulations on internal vehicle safety, as well as the regulations of the responsible vehicle manufacturers (general operating licence) must be observed.
Hearing damage: Sustained, excessive volume levels of over 85 dB can
permanently impair hearing. Stereo systems are capable of producing sound
pressure level of over 85 dB.
Sound level and perception: The use of stereo systems can impede the hearing
of important sounds and signals in traffic and thus lead to hazards while
driving. GLADEN assumes no responsibility for hearing damage, physical injury
or property damage resulting from the use or misuse of its products. Working
on vehicles: Do not operate vehicles un l all retrofitted components (speaker
boxes, speakers, amplifier, DSP, …) are securely installed. Loose parts can
become dangerous (flying) projectiles in the event of a sudden driving
maneuver or an accident. Do not drill or screw into vehicle panels or sheet
metal un l you are sure that there are no important parts, cables or lines
underneath. Pay attention to things like fuel, brake, oil lines and electrical
cables as preparation for installation when planning the system. Disconnect
the earth terminal (-) from the vehicle battery (auxiliary batteries) before
star ng installation to avoid possible short circuits. If body panels are to
be machined or removed for mounting the speakers or amplifiers, contact an
appropriate specialist workshop. In the event of damage to load-bearing
bodywork parts, the opera ng permit may be invalidated! Be careful when
removing interior panels. The vehicle manufacturers use a wide variety of
fastening elements (clips, screws, rivets, …) which can be damaged or may be
damaged during dismantling (dents or scratches on surfaces (e.g. metal sheets
may rust)).
Electricity danger! DO NOT touch the connections of the amplifier or the
speakers during opera on!
Electric and hybrid vehicles! There is danger to life! Do not any work on the
electrical system by yourself!
Information on disposal of old electrical and electronic equipment (applicable for countries that have adopted separate waste collection systems): Products with the symbol (crossed-out wheeled bin) cannot be disposed of as household waste. Old electrical and electronic equipment should be recycled at a special waste facility. Contact your local authority for details in locating a recycle facility nearest to you. Proper recycling and waste disposal will help conserve resources whilst preventing detrimental effects on your health and the environment. This product can be disposed of with the used car together. In this case don’t remove it from the car.
Thank you for choosing a GLADEN RSX SLIM Line- Subwoofer.
Each GLADEN RSX SLIM Line- Subwoofer chassis has been carefully designed and built to meet the high demands in the vehicle.
Please read the information in this document carefully to get the most out
of your GLADEN RSX SLIM Line – Subwoofers.
When opera ng the GLADEN RSX SLIM Line- Subwoofers, we recommend that you
achieve a good power match between the subwoofer amplifier and the subwoofer
driver.
The power specifications listed in each case represent the continuous (RMS)
amplifier power per subwoofer and assumes that the user regularly fully
utilizes this power without drastically overdriving the amplifier
(clipping).
Performance recommendation for trouble-free operation
|
200 Watt
| 500 Watt|
800 Watt
---|---|---|---
RSX 08 SLIM – D2|
RSX 10 SLIM – D2|
For optimal bass reproduction, the input sensitivity of the amplifier must be
set to avoid excessive distortion (clipping) at the amplifier output.
Excessive input sensitivity settings will not only lead to overloading, but
also to poor sound quality and reduced speaker reliability.
With subwoofers, an overdriven amplifier can be noticeable as a soft,
“mechanical” noise from the speakers. Correctly setting the input sensitivity
avoids this problem.
Interconnection of multiple subwoofers
4 Ω 1 Ω
2 Ω
0,5 Ω
Specification / Speaker | RSX 08 SLIM – D2 | RSX 10 SLIM – D2 |
---|---|---|
Power | 225 / 450 Watt | 250 / 500 Watt |
DC resistance | 2 x 1,8Ohm | 2 x 1,8Ohm |
Nominal Impedanz | 2 x 2Ohm | 2 x 2Ohm |
Resonance frequency | 44 Hz | 42 Hz |
Voice Coil diameter | 1,5 inch | 2 inch |
Electrical Q factor /Qes | 0,6 | 0,6 |
Total Q factor /Qts | 0,58 | 0,58 |
Moving mass / Mms | 64 g | 107 g |
Effective piston area / Sd | 210 qcm | 350 qcm |
Equivalent air volume / Vas | 12,7 Liter | 23,4 Liter |
SPL 2,83V/1m | 84,5 dB | 86,6 dB |
Diameter:
External diameter / A| 214mm| 261mm
Installation diameter / B| 179mm| 230 mm
Installation depth / C| 75 mm| 82 mm
Magnet diameter / D| 132 mm| 155 mm
Recommended Boxes (including Ports and Drivers)
Sealed Box
Gehäuse:
| Volume:
---|---
RSX 08 SLIM D2| ab 10 Liter
RSX 10 SLIM D2| ab 16 Liter
Vented Box
Gehäuse:
| Volume:| Port (diameter):| Port (length):
---|---|---|---
RSX 08 SLIM D2| 16 Liter| 60 mm| 350 mm
RSX 10 SLIM D2| 30 Liter| 70mm| 250mm
Technical characteristics of the RS series:
Cone: Polypropylen
Surround: Rubber
Basket: Steel
Double voice coil
Spider: Nomex
Coil Former: Aluminum
Dust cap: Polypropylen
Connection: Push terminals
Notes:
We wish you a lot of fun with your new subwoofer. Your Gladen Europe GmbH
Mistakes, misprints and technical changes reserved.
GLADEN EUROPE GmbH
Bertha-Benz-Str. 9
72141 Walddorfhäslach
Telefon: 07127 810 2820
Telefax: 07127 810 2899
www.gladen.com
E-Mail: info@gladen.com
Z-SUB-RSX-SLIM-ANL
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>