GLADEN D2 RS-X 10 RSX Slim Subwoofer Owner’s Manual

: June 9, 2024
: GLADEN

Table of Contents

GLADEN D2 RS-X 10 RSX Slim Subwoofer
Product Information
Product Usage Instructions
Safety Instructions
Performance recommendation for trouble-free operation
Specification
Technical characteristics of the RS series
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

GLADEN D2 RS-X 10 RSX Slim Subwoofer

GLADEN-D2-RS-X-10-RSX-Slim-Subwoofer

Product Information

GLADEN RSX SLIM Line- Subwoofer

The GLADEN RSX SLIM Line- Subwoofer is a high-quality subwoofer designed to meet the demands of vehicle audio systems. The product has been carefully designed and built to ensure optimal bass reproduction and reliable performance. The subwoofer driver comes in two models: RSX 08 SLIM – D2 and RSX 10 SLIM – D2, with power specifications of 200 Watt and 500 Watt respectively.

Safety Instructions

It is important to read all notes and warnings in the instruction manual before using the product. The product is only suitable for users with specialist knowledge. It is important to observe the relevant safety regulations for load-bearing body parts, internal vehicle safety, and the regulations of the responsible vehicle manufacturers. It is also important to avoid touching the connections of the amplifier or speakers during operation to prevent electrical danger. For electric and hybrid vehicles, do not attempt any work on the electrical system by yourself to avoid danger to life.

Product Usage Instructions

To get the most out of your GLADEN RSX SLIM Line – Subwoofers,it is recommended that you achieve a good power match between the subwoofer amplifier and the subwoofer driver. The power specifications listed in each case represent the continuous (RMS) amplifier power per subwoofer, and it is assumed that the user regularly fully utilizes this power without drastically overdriving the amplifier (clipping).

For optimal bass reproduction, it is important to set the input sensitivity of the amplifier to avoid excessive distortion (clipping) at the amplifier output. Excessive input sensitivity settings will lead to overloading, poor sound quality, and reduced speaker reliability. With subwoofers, an overdriven amplifier can be noticeable as a soft, mechanical noise from the speakers.
Correctly setting the input sensitivity avoids this problem.

The GLADEN RSX SLIM Line- Subwoofer driver comes in two models:
RSX 08 SLIM – D2 and RSX 10 SLIM – D2, with power specifications of 200 Watt and 500 Watt respectively. To interconnect multiple subwoofers, follow the wiring diagram provided in the instruction manual. The subwoofer driver has a polypropylene membrane and cone,rubber surround, steel basket, and a double voice coil. The product has an external diameter of 214 mm – 261 mm, installation diameter of 179 mm – 230 mm, and an installation depth of 75 mm – 82 mm.

It is recommended to ensure that the volume of the subwoofer enclosure is at least 10 liters for RSX 08 SLIM – D2 and 16 liters for RSX 10 SLIM – D2. The technical characteristics of the RS series include a resonance frequency of 42 Hz – 44 Hz, a voice coil diameter of 1.5 inch – 2 inch, and an effective piston area of 210 qcm – 350 qcm.

For any inquiries or technical assistance, please contact GLADEN EUROPE GmbH at telephone number 07127 810 2820 or fax number 07127 810 2899.

Safety Instructions

Please read all notes and warnings in this manual.
These will not only inform you about possible damage or injury, but also about possible functions and settings.
Our products are only suitable for users with the necessary specialist knowledge. The relevant safety regulations for load-bearing body parts, regulations on internal vehicle safety, as well as the regulations of the responsible vehicle manufacturers (general operating licence) must be observed.
Hearing damage: Sustained, excessive volume levels of over 85 dB can permanently impair hearing. Stereo systems are capable of producing sound pressure level of over 85 dB.
Sound level and perception: The use of stereo systems can impede the hearing of important sounds and signals in traffic and thus lead to hazards while driving. GLADEN assumes no responsibility for hearing damage, physical injury or property damage resulting from the use or misuse of its products.
Working on vehicles: Do not operate vehicles until all retrofitted components (speaker boxes, speakers, amplifier, DSP, …) are securely installed. Loose parts can become dangerous (flying) projectiles in the event of a sudden driving maneuver or an accident. Do not drill or screw into vehicle panels or sheet metal until you are sure that there are no important parts, cables or lines underneath. Pay attention to things like fuel, brake, oil lines and electrical cables as preparation for installation when planning the system. Disconnect the earth terminal (-) from the vehicle battery (auxiliary batteries) before starting installation to avoid possible short circuits. If body panels are to be machined or removed for mounting the speakers or amplifiers, contact an appropriate specialist workshop. In the event of damage to load-bearing bodywork parts, the operating permit may be invalidated! Be careful when removing interior panels. The vehicle manufacturers use a wide variety of fastening elements (clips, screws, rivets, …) which can be damaged or may be damaged during dismantling (dents or scratches on surfaces (e.g. metal sheets may rust)).
Electricity danger! DO NOT touch the connections of the amplifier or the speakers during operation !
Electric and hybrid vehicles! There is danger to life! Do not any work on the electrical system by yourself!
Information on disposal of old electrical and electronic equipment (applicable for countries that have adopted separate waste collection systems):
Products with the symbol (crossed-out wheeled bin) cannot be disposed of as household waste. Old electrical and electronic equipment should be recycled at a special waste facility. Contact your local authority for details in locating a recycle facility nearest to you. Proper recycling and waste disposal will help conserve resources whilst preventing detrimental effects on your health and the environment. This product can be disposed of with the used car together. In this case don’t remove it from the car.

Thank you for choosing a GLADEN RSX SLIM Line- Subwoofer.
Each GLADEN RSX SLIM Line- Subwoofer chassis has been carefully designed and built to meet the high demands in the vehicle.
Please read the information in this document carefully to get the most out of your GLADEN RSX SLIM Line – Subwoofers.
When operating the GLADEN RSX SLIM Line- Subwoofers, we recommend that you achieve a good power match between the subwoofer amplifier and the subwoofer driver.
The power specifications listed in each case represent the continuous (RMS) amplifier power per subwoofer and assumes that the user regularly fully utilizes this power without drastically overdriving the amplifier (clipping).

Performance recommendation for trouble-free operation

GLADEN-D2-RS-X-10-RSX-Slim-Subwoofer-1

GLADEN-D2-RS-X-10-RSX-Slim-Subwoofer-2

For optimal bass reproduction, the input sensitivity of the amplifier must be set to avoid excessive distortion (clipping) at the amplifier output. Excessive input sensitivity settings will not only lead to overloading, but also to poor sound quality and reduced speaker reliability.
With subwoofers, an overdriven amplifier can be noticeable as a soft, “mechanical” noise from the speakers. Correctly setting the input sensitivity avoids this problem.

Interconnection of multiple subwoofers

GLADEN-D2-RS-X-10-RSX-Slim-Subwoofer-3