THIN AIR BRANDS HD965 Hyper Drive Light and Sound RC Instruction Manual
- June 1, 2024
- Thin Air Brands
Table of Contents
THIN AIR BRANDS HD965 Hyper Drive Light and Sound RC
Product Information
Specifications
- Model: [Product Model]
- Power Source: 3 x LR44(1.5V) for Try Me Button, 5 x AA (not included)
- Recommended Age: [Age Recommendation]
- Material: [Product Material]
- Dimensions: [Product Dimensions]
Product Usage Instructions
Battery Installation
- Ensure the product is turned off before installing batteries.
- Follow the polarity markings inside the battery compartment to insert 3 LR44 batteries for the Try Me Button and 5 AA batteries for regular operation.
Turning On/Off
- To turn on the product, locate the power button or switch and press or slide it to the “ON” position.
- To turn it off, repeat the same process to switch it to the “OFF” position.
Safety Precautions
- Always keep batteries out of reach of children. In case of swallowing or insertion, seek immediate medical attention.
- Do not mix old and new batteries or different types of batteries.
FAQ
- Q: What type of batteries does the product require?
- A: The product requires 3 LR44(1.5V) batteries for the Try Me Button and 5 AA batteries for regular operation.
- Q: Are the AA batteries included with the product?
- A: No, the 5 AA batteries are not included. You will need to purchase them separately.
Operating Instructions
BATTERY CONSIDERATIONS
- This product and the remote control use 1.5V “AA” non-rechargeable batteries.
- The battery should be taken out and installed in correct polarity and voltage to avoid short circuits. 3) Non-rechargeable batteries cannot be charged.
- Rechargeable batteries must be charged under adult supervision.
- The rechargeable battery should be removed from the toy before charging.
- Different types of batteries or old and new batteries cannot be mixed.
- Only batteries that are the same as or equivalent to the recommended batteries can be used.
- The exhausted battery should be taken out of the toy. If it is not used for a long time, please take out the battery from the toy. 9) The power terminals should not be shortcircuited.
- Never connect to the power sources which are more than recommended.
WARNING
- INGESTION HAZARD: This product contains a button cell or coin battery.
- DEATH or serious injury can occur if ingested.
- A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours.
WARMING
- KEEP new and used batteries OUT OF REACH of CHILDREN
- Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.
- Requires 3 x LR44(1.5V) batteries in Try Me Button
WARNING
- CHOKING HAZARD-Small parts.
- Not for children under 3 years.
Requires 5 x “AA” batteries (not included)
- 3×1.5V “AA”-Batteries Not Included (Car unit)
- 2×1.5V “AA”-Batteries Not Included (Remote Controller)
- Remove and immediately recycle or dispose of used batteries according to local regulations and keep them away from children. Do NOT dispose of batteries in household trash or incinerate
- Even used batteries may cause severe injury or death
- Call a local poison control centre for treatment information
- Battery type: LR44
- Battery voltage: 1.5V
- Do not force discharge, recharge, disassemble, heat over 26°C or incinerate. Doing so may result in injury due to venting, leakage or explosion resulting in chemical burns.
- Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep them away from children.
IN THE INTEREST OF BETTER QUALITY AND VALUE, WE ARE CONSTANTLY IMPROVING AND UPDATING OUR PRODUCTS. CONSEQUENTLY, PICTURES ON THIS PACKAGE MAY SOMETIMES DIFFER FROM THE MODEL ENCLOSED.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, according to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environm ent. This transmitter must not be co‐located or
operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>