GROOVE PRO Slat Wall without J Trim Wood Panel Instruction Manual
- June 1, 2024
- GROOVE PRO
Table of Contents
GROOVE PRO Slat Wall without J Trim Wood Panel
Installation Instruction
- Locate the studs.
- Install the first piece of GroovePro.
- Level the first piece of GroovePro before screwing.
- Screw the first piece of GroovePro into the studs.
- Install the next piece of Groovepro on top of the first one and screw it into the studs.
Concrete Installation
If you are installing GroovePro on concrete, pre-drill the concrete with a
5/32 drill bit. Space concrete screws about 1 ft apart.
- Locate the studs.
- Install the fist J-trims horizontally, level it and then screw it into de studs.
- Install the second J-trims vertically, level it and then screw it into de studs.
- Install the first piece of GroovePro. Make sure to install it inside the J-trims.
- Screw the first piece of GroovePro into the studs.
- Install the next piece of GroovePro on top of the first one and screw it into the studs.
CONTACT
MEX: +52 55 2122 3990 ext. 229
MEX: +52 55 4810 1714
USA: +1 (424) 296 8697
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>