Space Tech EPS03 Portable Wireless Speaker Instruction Manual
- June 1, 2024
- Space Tech
Table of Contents
Space Tech EPS03 Portable Wireless Speaker
OVERVIEW
- /7.Short press to increase or decrease the volume, long press to switch songs/switch stations
- Mode：It to toggle between USB/TF/Bluetooth/AUX
- Short press for the mode change of sound，Press and hold for TWS
- Short press：Play/Pause
- Long press:：Power on/off
- Light Mode Transition
- 3.5mm headphone jack
- USB interface
- TF card interface
- 5V 2.5A Type_C charging port
- Reset key
- Microphone connector
CHARGING
Plug the charging cable into the speaker and connect to another USB power source such as a PC, MAC, USB power adapter, etc.
The symbol above and on the product means that the product is classed as equipment and should not be disposed with other household or commercial waste at the end of its useful life.
The Waste of Electrical and Electronic Equipment (WEEE) Directive has been put in place to recycle products using best available recovery and recycling techniques to minimise the impact on the environment,
Contact local authorities for information on the correct disposal of Electrical or Electronic equipment.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Portable
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>