Renin 30in x 84in Barn Doors and Hardware Included Installation Guide
- June 1, 2024
- Renin
Table of Contents
Renin 30in x 84in Barn Doors and Hardware Included
Specifications
| Component | Description |
|---|---|
| A1-A2 | Door vertical panels |
| B1 | Top horizontal rail |
| B2 | Bottom horizontal rail |
| B3 | Central horizontal rail |
| C1 | Vertical slats (right side) |
| C2 | Vertical slats (middle) |
| C3 | Vertical slats (left side) |
| E | Screw (3.5 inch) |
| F | Handle |
| G | Allen wrench |
Dimension
Required Tools
Assembly Instructions
- Align the top (B1), central (B3), and bottom (B2) horizontal rails between the left (C3) and right (C1) vertical panels. Insert the middle vertical slats (C2) into the grooves provided.
- Use the provided screws (E) to secure the panels and rails together. Do not over-tighten the screws to avoid damaging the wood.
- Attach the handle (F) to the door using the screws provided.
- Use the Allen wrench (G) to make any necessary adjustments.
Diagram Descriptions
The diagrams provide a visual layout of the door assembly process:
- Diagram 1 shows an exploded view of the door components, with labels for each part.
- Diagram 2 illustrates step 1 of the assembly, showing the alignment of the horizontal rails (B1, B3, B2) and the vertical panels (A1, C1, C2, C3).
- A separate detail shows a ‘tongue and groove’ joint, indicating how the vertical slats (C2) fit into the horizontal rails (B1, B3, B2).
- At the bottom, a caution note states “Do not overscrew,” emphasizing the importance of not over-tightening the screws (E).
- Diagram 3 provides a front view of the assembled barn door, indicating the downward direction for securing the components together.
FAQ
What tools are needed for the installation?
The provided Allen wrench (G) and the screws (E) are necessary for the
installation. A screwdriver is likely needed to drive the screws.
How do I prevent damaging the panels when screwing them together?
Be cautious not to over-tighten the screws. The note “Do not overscrew” is
a reminder to avoid applying excessive force.
Where do I attach the handle?
The handle (F) should be attached to the door after all panels and rails
are secured. The exact positioning may depend on personal preference or design
specifications.
How do I adjust the door if it’s not fitting correctly?
Use the Allen wrench (G) for any necessary adjustments to the door
components during or after installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>