TATZE Manual Refresh Kit Instructions
- June 1, 2024
- TATZE
Table of Contents
Manual Refresh Kit
Instructions
Manual Refresh Kit
Manual Refresh Kit suitable for
LINK Composite, LINK, LINK TI, TWO-FACE Composite, CONTACT CNC
Refresh Kit consisting of:
- Ball bearing (4x)
- Plain bearing (2x)
- Weals (4x)
- Grease (1x)
- Hexagonal PIT (1x)
- Tool with washers (1x)
Dismount Axle
1.1. Unscrew the end cap with an Allen key. Hold the pedal while doing so.
1.2. Unscrew
the axle in the opposite direction using the hexagon and Allen key
included.
ATTENTION!
Left pedal => RIGHT THREAD!
Right pedal => LEFT SPEED!
1.3. Bearing and axle set in disassembled status2.1. Carefully tap out the ball bearing and then
clean the socket properly.
Press in bearings & assembly
2.1. Slide the plain bearing over the tool with the bevel first and press it
in straight by hand with the washer.2.2. Place the convex washer on the tool and push in the
ball bearing (A). Press in by hand and screw in completely with end cap (B).
Then remove the end cap again.
2.3. Slide the seals onto the axle, put some grease into the plain bearing
bushing and onto the seals and slowly slide the axle into the pedal body. 2.4.
Insert nut and apply washer with a little grease. Then tighten with hexagon
and Allen key in opposite direction with approx. 10 Nm.2.5 Screw in the end cap with an Allen key and
approx. 10 Nm on aluminum pedals and 2.5 Nm on composite pedals. Hold the
pedal while doing so. FINAL CHECK!
Axles must rotate well and be firmly connected to the pedal body.
DONE!
The 1×1 of pedal sides
Left axle with notch & Black nut. Right axle without notch & silver nut.
Manual Version 230330
TATZE bike-components GmbH
Tyrol/Ausria
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>