Absco GBCAP120 Hex Raised Garden Bed Instruction Manual
- June 1, 2024
- Absco
Table of Contents
Absco GBCAP120 Hex Raised Garden Bed
Product Information
Specifications
- Model: OGC50H-PTX
- Type: Hexagonal Raised Garden Bed
- Material: Steel
- Dimensions: 3.28ft diameter
Product Usage Instructions
Assembly Overview
The OGC50H-PTX Hexagonal Raised Garden Bed comes with the following components:
- 4 x GBP12031 Posts
- 4 x GBCAP120 Caps
- 6 x GBS30045 Sheeting Parts
First Steps
- Using safety gloves, unpack the carton and check off all parts against the packing list.
- Slide the sheets into the posts following the SNAPTiTE Assembly System.
- Gently tap components into position using a rubber mallet.
Important Installation Note
It is crucial to install the garden bed on a flat and even surface to prevent leakages and ensure even weight distribution. Incorrect installation will void the warranty.
Product Maintenance
Regularly check for any loose components or signs of wear and tear. Clean the garden bed as needed to maintain its appearance and longevity.
FAQ
- Q: What should I do if I encounter difficulties during assembly?
- A: If you face any challenges during assembly, refer to the provided diagram or contact our customer service at 1800 029 701 for assistance.
- Q: How can I register my warranty?
- A: Visit www.organicgardenco.com.au/warranty before June 15,2023, to register your warranty online.
Dimension
PACKING LIST
IMPORTANT
It is advised that you install your garden bed on a flat/even surface to avoid leakages and maintain an even weight distribution. Incorrect installation will void the warranty.
FIRST STEPS
Using safety gloves, unpack your carton. Check off the parts using the packing list. When assembling, most parts should slide together with minimal effort. Use a rubber mallet to gently tap components into position. Any questions? Call us on 1800 029 701.
SLIDE SHEETS INTO POSTS
Organic Garden Co garden beds use the SNAPTiTE Assembly System. Ensure that
the lugs in the steel sheet click into the posts correctly, see below diagram
SAFETY CAPS
Clip on the safety caps to each post. Use a mallet to tap into place if
necessary.