XELON AUDIO M728CP Car Multimedia Player User Manual
- June 1, 2024
- XELON AUDIO
Table of Contents
AUDIO M728CP Car Multimedia Player
User Manual
Warning
For your safety, the driver should not operate the controls while driving AIso
, while driving , keep the volume to a level at which external sounds can be
heard .
precautions
-
when the interio r of the car is extremely cold and the unit is used soon after switching on the heater and moisture may form on the unit and as a result ,the player and proper playback may not be possible. Wipe any moisture off with a soft cloth.
Driving one extremely bumpy or rough roads can cause the disc to skip during p layback -
his unit uses precision parts and components for its operation .In the event that trouble arises ,never open the case ,disassemble the unit ,or lubricate the rotating parts .Contact your service center.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This quipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance between 20cm the radiator your body.
Wiring Back Panel
Please check the speaker line carefully before
installation. If any grounding or touching, please connection again, otherwise
the unit will be burned.
General Operation
Note: if there is no any device connection , some icons like camera will
be showed no device.click is invalid in this case .Display setting is invalid
if there is no audio or video playing
Radio
-
Radio Region-Set the unit for one for the following regions: Europe.
America, China, Russia, Japan, RDS(on/off) Multimedia player -
Support lots of video and audio formats
-
Subwoofer-Turn the subwoofer Output On or Off
-
Q-setting :Pop ,ROCK ,Classic ,Jazz or off
Time -
slide the figures in the set time interface
Language -
Language-Select desired language(English, Spanish, Deutsch, Russian,
Portuguese , French, Chinese,etc. camera input -
Connect the camera with this device. can be auto detected brake signal when reversing.(Note camera is not included) car logo
-
Preset car logo to match your car brand
Steering wheel control -
Set the function button on you steering wheel via the system learning setting calibration
-
Calibration Press the enter of the “+” as the indicated on the screen to calibrate the touch screen Power saving mode AUX Input
-
Connect an optional audio video source to the Aux input
FM Tuner Operation
Radio interface RDS turn on function
Touch Radio icon in main interface or press mode key in panel/SRckey in remote
controller to switch to radio mode.
Multimedia player
Support avarity of audio and video formats
Music interface
The system will automatically read certain devices inputted into the unit The
user can directly click options in directory menu to perform play.
Note: Sliding the controlling bar in the bottom to show the next page.
AUX in(Auxiliary device input
Click ” AUX In” in from the main interface SRC key in remote control to switch
to AUX in Mode. AUX in enables external media sources to connect to the
system, like camera, video games, etc (controlled by remote control}. No
auxiliary device input shows at the below picture. Connect external devices
through the 3.5mm auxiliary audio/video input. It can display the
corresponding picture as the output video.
Rear view Camera
Auto operation: After connect with reverse camera, it will auto-detected the
reverse signal and show the reverse pictures. The system will swift to any
mode to rear view lens mode automatically. When reverse is over, the system
will come back to previous mode.
PHONE connects your device to your mobile phone through the standard port and
transfers the picture and audio from the phone to the device. You can control
the phone through the device’s screen , such as receiving calls, dialing
calls, listening to music, watching movies or photos.
Connect your device using the with original cable your phone came with, then
touch the phone icon to open the menu, and follow the instructions.
setting
Note: sliding the baron the left side to see more optional settings
Connect the steering wheel control cable, and click the corresponding key to
activate the function.
After entering into the steering wheel control interface. then keep pressing
the steering wheel “VOL+” button in your car, at the same time click “in the
interface, it will be selected, then it is finish this setting. Click other
buttons according this method, the steering wheel function can be used.
Troubleshooting
| Phenomenon | Reasons | Solutions |
|---|---|---|
| Normal | ||
| Not operating | Fuse of machine power supply and auto vehicle battery is burnt, |
Volatge of power supply is overloaded Automatic protection system avoids fault
due to illegal operation
Wrong pin assignment ISO connector| Change forfuse of the
collect types;
Adjust voltage;
Reset the system by pressing the Resetkey Check the wiring
diagram
Remote comtrol doesn’t work| Battery is out of power, Battery is not placed
correctly| Change new battery; Reinstall battery
Noor low sound| Disconnection;
Volume setting is low volume; wrong connection of Silence; Loudspeakerfault;
Volume balance setting bias Earthing in loudspeaker connection| Check the
connecion; Increase the
volume; Reconnection the silence wire complied with the installation
instruction; Change for a new loudspeaker, Adjust the volume balance setting
to middle place;
| |
Machine reset b} itself when it is shutdown| Connection ofACC and B+ is not
correct.| Check and reconnect ACC and B+
Turnover screen| |
Tumover screen does not open automatically.| Auto Open of turnover screen
setting is OFF.| Auto Open»ON
No image| Connection of brake wire is not correct; Not brake state| Connect
brake wire with cathode of power supplycorrectly; Keep brake state after car
is placed safe.
Unstable output of images| does not correspond with the present system video
setting; Video signal line is not connected correctly.| Adjust system video
setting; Check and make sure of the connectivity. Unsupported code
Images being stretched or compression| Inappropriate image proportion setting|
Adjust image setting
Trouble| Cause(sl| Solution Cs)
---|---|---
Radio| |
Weak signal| Auto antenna does not reach out completely LOG function is under
workina state| Connect auto antenna line correctly; Close LOG function.
Note: This device is a Mechless unit.
systematicparamete
| specifications | FMRadio |
|---|---|
| workingvoltage :directcurrent 12v | Frequencymodulation |
87.5MHZ~108.0MH2Z(Europe)
workingvoltage range :10.8v-16v| Flexibilty(- 30 dB): 10dBU SNR(-50dB): 15dBU
Maximumworkingelectroniccurrent :10A| Frequentsound range: 30H2~15KHZ(+3dB
Installation angle: less than 30 degree. tilted thefrontsideandbackside|
AMRadio
poweroutput: 4 x 80w| Frequency range
impedance4ohm SNR: 70dBA| 522KHZ-1620KHZ( Europe)
FrequencyResponse :20HZ-20KHZ| sensitivity( SN=20dB):20dBU
video| Imagerejection :‘60dB
standards:NTSC .PAL(Autorecognition)| Frequencyresponse:
output :2vp-p(75o0hm)| §0HZ-2KHZ(+-3dB)
Input : 1 vp-p(75ohm)| Display
| screentype: TFT
| Responsetime :up=30millisecond Down= § 0 millisecond
| Anglerange:depressionangle=65 elevationangle= 4 0
| Leftvision=6 5 rightvision=65
| Environmenttemperature
| operationtemperature:-20~+70°c
| Maintenance temperature: -30°C~80°C.
| operatinghumidity:45% ~ +80%, c (relativehumidity)
| Maintenancehumidity:30%~90% (relativehumidity)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>