Honeywell 5530M Wiring Uplink Cellular Communicators Instruction Manual
- June 1, 2024
- Honeywell
Table of Contents
- Honeywell 5530M Wiring Uplink Cellular Communicators Instruction Manual
- Honeywell Vista 15SE
- CAUTION:
- Wiring the 5530M communicators to Honeywell Vista 15SE
- Programming the Honeywell Vista 15SE Alarm Panel via the Keypad
- Enable Contact ID reporting:
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Honeywell 5530M Wiring Uplink Cellular Communicators Instruction Manual
Honeywell Vista 15SE
Wiring Uplink’s 5530M Cellular Communicators and Programming the Panel
CAUTION:
- It is advised that an experienced alarm installer programs the panel as further programming may be required to ensure proper performance and use of the full
- Do not route any wiring over circuit
- Full panel testing, and signal confirmation, must be completed by the
NEW FEATURE: For 5530M Communicators, the status of the panel can be
retrieved not only from the status PGM but now also from the Open/Close
reports from the dialler.
IMPORTANT NOTE: The Open/Close reporting needs to be enabled during the
initial pairing procedure.
Wiring the 5530M communicators to Honeywell Vista 15SE
Programming the Honeywell Vista 15SE Alarm Panel via the Keypad
Enable Contact ID reporting:
| Keypad Display | Keypad Entry | Action Description |
|---|---|---|
| DISARMED | 4112800 | To enter programming menu. |
| Installer Code | *41 | To start configuring primary phone number. |
| Pri. Phone | 123456* | Enter phone number value and press * to save and go back. |
| Field? | *43 | To start configuring “Part. 1 Primary Subs. Acct. No.” |
| Pri SubId | 1234* | Enter account number value and press * to save and go back. |
| Sec SubId | *45 | To enter “Phone system select” menu. |
| Phone Sys | 1* | To select “Tone Dial” and go back. |
| Field? | *46 | To enter “Report format” menu. |
| Rep Form Pri/Sec | 7* | To select “Ademco Contact ID” for primary phone number. |
| Field? | *65 | To go to “Open report code” setup. |
| Open Rpt | 1* | To enable reporting for “Open” event. |
| Field? | *66 | To go to “Arm Away/Stay Report Code” menu. |
| Awy/Sty Rp | 1, 1* | To enable reporting for “Away/Stay” events. |
| Field? | *92 | To go to “TLM” menu. |
| Telco Monitor | 0* | To disable TLM and save. |
| Field? | *99 | To exit programming mode. |
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>