Truwelby HC006 Baby High Chair Owner’s Manual
- June 1, 2024
- Truwelby
Table of Contents
HIGH CHAIR
Owner’s Instruction
HC006 Baby High Chair
Read all instructions before assembly and use.
Keep instructions for future use.
IMPORTANT! KEEP FOR FUTURE REFERENCE.
WARNING! TO BE ASSEMBLED BY ADULT!
THIS PRODUCT NOT APPLICABLE TO BABY WHO CAN NOT SEAT UNAIDED.
WARNING DO NOT adjust the height of the seat while the child is seating in the chair.
WARNING
Read the instructions carefully before WARNING use and keep them for future
reference.
The child may be hurt if you do not follow these instructions.
- The highchair suitable for children who are able to sit up unaided( approximately 6 months-36 months).
- It’s not intended for children weighing more than 25kgs.
- Do not use the highchair until the child can 4 sit unaided.
- Do not use the highchair unless all components are correctly fitted and adjusted.
- Do not leave your child unattended, even for a short time.
- To prevent serious injury or death from falls or sliding out, ensure the harness is correctly fitted and the child is secure in the restraint.
- Avoid placing the highchair near naked heat sources such as electric bar fires, gas fires, etc. or where a child could gain access to any other kind of hazard.
- Ensure all users are familiar with the product operation. It should always open and fold easy. If it does not, do not force the mechanism-stop and read the instructions.
- Only use on a flat and stable surface.
- Ensure highchair is fully erected before placing touchily inside.
- Ensure children are clear of all moving parts before making any adjustments. Do not move highchair with your child inside.
- Do not allow your child to climb unassisted into, play with or hang onto your highchair. This is not a t0¥.
- All additional hazards such as electrical fire flex should be kept out of reach of the child in the highchair.
- Prohibit the use of any accessories provided by non-manufacturers, if any parts are damaged or lost, please discontinue use.
- Complies with EN14988:2017+A1:2020
Product Care and Maintenance
- Check regularly the frame for signs of damage or wear.
- Clean the plastic parts with a damp cloth.
- Clean the seat by sponging with warm soapy water and a mild detergent.
- Dry the metal parts to prevent the formation of rust.
- Prolonged exposure to direct sunlight may cause the fabric to fade.
Part list
A. Seat unit
B. Left and right feet
C. Two part serving tray
Assembling Procedures
-
Press and hold down the round button and extend the leg then release the round button.
-
Press the button then press down the tray arm.
-
Take out the front and rear feet, turn the highchair upside down. Push firmly on the foot at either end until each of the two sprung pins click into place within the small hole in the foot. Repeat for the other foot.
-
Position the tray to the front of the arms, pull the front lever on the underside of the tray, whilst slide the tray along with the slot to the position required.
The tray has three positions as indicated on the arm rests. -
Ative-point safety harness is provided to restrain your child and should always be worn. To unfasten, push the button on the buckle and pull the clips clear.
To fasten, push the waist strap slips into the buckle until they lock in place.
Sliding adjusters are fitted on the shoulder straps and waist straps. The harness should be carefully adjusted so that it fits your child comfortably. -
Press the button then adjust the chair in the suitable position. 6 heights for choice.
-
To adjust the angle of the seat, lift the plastic lever on the back of seat, and position as required, release the mechanism to secure into place.
-
To adjust the footrest, push in both sides of button and simultaneously raise or lower the footrest, release both bottoms at the required position.
-
Release the levers to a required lock position until a double click is heard signalling the tray is securely locked.
How to fold the highchair
-
Adjust the backrest of the highchair to the vertical state and the highchair in the highest position. Remove the tray and place the tray in the slot position under the hind legs. Pull the tray arm upwards. Press the button then fold the highchair as shown in the illustration. Make sure the highchair fold properly then store it in a suitable place.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>