Schneider Electric CCT591012 Wiser Window Door Sensor Instruction Manual
- June 1, 2024
- Schneider Electric
Table of Contents
CCT591012 Wiser Window Door Sensor
Instruction Manual
CCT591012
CCT591012 Wiser Window Door Sensor
Wiser Window/Door Sensor
About this product
The Wiser Window/door sensor (hereinafter referred to as sensor) consists of
two separate parts: primary and secondary. The primary part includes the
sensing circuit which detects the secondary part. The secondary part is a
magnet.
When the sensor is connected to the Wiser Hub and the window/door is opened or
closed, the primary part directly reports the change to the hub.
Package contents
A Primary part (sensing circuit)
B Secondary part (magnet)
C Base plate
D Adhesive pad
E Screws: 2 × ST2 × 10 mm, 1 × M2 × 3 mm
F Installation instructions
Choose suitable location to install
G Vertical mounting options
H Horizontal mounting options
Installing the sensor
NOTICE
EQUIPMENT DAMAGE
- To avoid degrading sensor performance, do not install the sensor near magnetic devices.
- With the window/door in the closed state, the distance between the primary part and secondary part of the sensor should be <18 mm for a non-metallic base (for example, wood or plastic surfaces) and <10 mm for a metallic base.
Failure to follow these instructions can result in equipment damage.
(1) Remove the battery isolation strip
A LED flashes green
(2) Mount the base plate
a. Mounting using adhesive pads
For wood or plastic surfaces or metal surfaces, use the adhesive pads.
Note: For metal surfaces, use the adhesive pads only.
b. Mounting using screws
• For wood or plastic surfaces, use the screws.
• If using screws, pre-drill a 1 mm hole.
(3) Mount the sensor on the base plate.
Read full device guide online
Scan the QR code and choose your language for complete information about
the device, including operation, configuration and using the product with a
Wiser system.
Technical data
| Battery | 3 VDC, CR2450 |
|---|---|
| Battery life | Up to 5 years (may vary based on the usage, frequency of |
firmware update and environment)
Nominal power| 590 mW
IP rating| IP20
Operating frequency| 2405 – 2480 MHz
Max. radio frequency power transmitted| 57 dBm
Operating temperature| -10 °C to 50 °C
Relative humidity| 10 % to 95 %
Primary part dimensions (H x W x D)| 50.3 x 33 x 16.3 mm
Secondary part dimensions (H x W x D)| 50 x 9 x 9 mm
Communication protocol| Zigbee 3.0 certified
Trademarks
• Wiser™ is a trademark and the property of Schneider Electric SE, its
subsidiaries and affiliated companies.
• Zigbee® is a registered trademark of the Connectivity Standard Alliance.
Other brands and registered trademarks are properties of their relevant
owners.
EU Declaration of Conformity
Hereby, Schneider Electric Industries, declares that this product is in
compliance with the essential requirements and other relevant provisions of
RADIO
EQUIPMENT DIRECTIVE 2014/53/EU. Declaration of conformity can be downloaded
on: se.com/docs. Schneider Electric Industries SAS
If you have technical questions, please contact the Customer Care Centre in
your country. se.com/contact
References
- Schneider Electric Global | Global Specialist in Energy Management and Automation
- Contact Support | Schneider Electric Global
- Que Faire de mes Déchets ? Découvrez les solutions pour tous vos déchets et nos conseils pour en produire moins.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>