WOINNMM W01 Open Ear Wireless Headphones User Guide
- June 1, 2024
- WOINNMM
Table of Contents
WOINNMM W01 Open Ear Wireless Headphones User Guide
Customer Service
Package Contents
Product Overview
Product Specifications
- Model: W01
- Bluetooth version: V5.3+EDR
- Range: > 33FT (10M)
- Support: HSP/HFP/ A2DP/ AVRCP
- Frequency response: 20Hz-20KHz
- Talk time: > 8 hours
- Music time: > 8 hours
- Earbud charging time: 1.5 hours
- Earbud weight: 10g
- Charging case weight: 58g
- Charging case size: 112 x 62 x 27mm
- Earbud battery: 3.7V/40mAh
- Charging case battery: 3.7V/400mAh
- Charging case input voltage: DC 5V/500mA
Get Start
Activate the WOINNMM OWS Earbud:
Take the wireless earbuds out of the charging case first ,then put earbuds
back into the case .The case battery LED display will lights up and the red
indicator light of the earbud lights up as well.
Note:
when you put the earbuds back into the charging case, and the case battery LED
display is on, then the earbud is activated and in charging mode.
If the case LED display is off, please charge for the case via the USB-C
cable.
(More pairing details please refer to the below instructions) .
Headphone Paring
Step 1: Take out WOINNMM ows earbuds from the case, the ows earbud will power on automatically, following with voice prompt” power on”, then both Left(L) earbud and Right(R) earbud will auto- connect each other and you will hear voice prompt -“du”, now the ows earbuds in the pairing mode.
Step 2: Please search and connect the WOINNMM OWS bluetooth device name “W01” from bluetooth list via your phone or pod, you will hear the voice prompt – “connected”. Now the ows earbuds pairing successfully.
Note:
While connecting the W01 with your phone, Please check whether you can’t hear
the voice propmt” du” from the L/R earbud or you will see two the some device
name·”W01″ from bluetooth list, that all need re-pairing as above steps.
Attention
-
Auto-reconnect:
The ows earbuds will auto reconnect while the earbuds disconnected with the mobile phone due to some objective factors, you also will hear the voice prompt-Connected” after reconnect succeeded. -
Nano mode re-connect :
when you take out only one side earbud for second use, the earbud also will auto-connect with your phone, it will also enter in pairing mode if failed auto-connect with your phone, please manual connect in this situation( select the device name
from your phone by manually). -
Auto-connect between Left (L) and Right ( R) earbud
Normally the Left and Right earbud will auto-connect after they’re out from the case, and you will hearing the voice prompt-“du”, In case the Land R earbuds foiled auto-connect, please put them back in the case, then take them out for connect it again. -
Auto Power off
when you take out ows earbuds from the case and does not any connection, the earbuds will power off automatically in 5 minutes.
Charging
a. Charge for OWS earbuds
put the ows earbud in the charging case and charge for the earbud. The earbuds
flashes red light while charging
Low Battery Prompt:
If the earbud battery life is less than 3 . 2V a low battery prompt with”
dudu” and it will reminder with each 30
seconds, till the earbud automatically power off as the battery life under 3V
b. Charge the Charging case
- Charging way: USB-C cable
- Battery display digital LED display (DC 5V/400mA)
Touch Control
FCC Radiation Exposure Statement:
Note: This equipment has been tested and found lo comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
POWER:DC5V
FCC ID:2A7IT-W01
MADE IN CHINA
After-sell: woinnmm2023@outlook.com
WARRANTY CARD
Warranty period:
The warranty period of this product is 12 months from the date of purchase
(non-human damage).
Quality Assurance Service:
(1) This product is in the period of warranty. any defective caused by the
quality of the product(only limited to non-human damage), please use this
warranty card to get in touch with the dealer to enjoy the warranty service.
(2) Our warranty service does not include the freight of repair products and
door-to-door service.
The user not entitled to quality assurance service as below clauses:
- No warranty card or product repair label was damaged;
- Damage caused by user’s disassembly;
- Man-made damage caused by serious falls, water inflowed ….
- Failure or damage caused by force majeure.
Customer Service Information
Documents / Resources
|
WOINNMM W01 Open Ear Wireless
Headphones
[pdf] User Guide
W01 Open Ear Wireless Headphones, W01, Open Ear Wireless Headphones, Ear
Wireless Headphones, Wireless Headphones
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>