TAGARNO 2024 Calibration Ruler Instruction Manual
- June 1, 2024
- TAGARNO
Table of Contents
TAGARNO 2024 Calibration Ruler
Product Information
Specifications
- Product: Calibration Ruler
- Length: 180 mm
- Version: 2022.10.13
- Optimized for printers pushing long side or short side of paper out first
- Suitable for close-up lens: +2
Product Usage Instructions
Printing Instructions
- Set scaling to None, 1:1, or 100%
- Print on heavy paper, preferably 200 g/m² (53lb)
- Ensure the printer pushes the correct side of the paper out first (long or short side)
Calibration Process
- After printing, use an office ruler to verify that the ruler is exactly 180 mm long
- Any calibration ruler not meeting the criteria should be discarded
- For ease of use, the verified ruler can be cut out
Additional Information
- The printing direction may affect the accuracy of the ruler, so ensure proper alignment during printing.
FAQ
Q: How do I know if my printer pushes the long or short side of the paper out first?
A: Refer to the printer settings or perform a test print to determine the paper exit direction.
Q: Can I use a different paper weight than 200 g/m² for printing?
A: It is recommended to use heavy paper of at least 200 g/m² for accurate results.
Q: What should I do if the printed ruler does not measure exactly 180 mm?
A: Discard any calibration ruler that does not meet the specified length for accurate calibration.
CALIBRATION RULER
Instructions for printing
- Set scaling to None, 1:1 or 100 %
- Print on heavy paper, preferably 200 g/m (53lb)
- Please note if the used printer pushes the long or short side of the paper out first.
- The printing direction may affect the accuracy of the ruler.
- After printing, use an office ruler to verify that the ruler is exactly 180 mm long.
- Any calibration ruler that does not meet these criteria should be discarded.
- For ease of use, the verified ruler can be cut out.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>