Abode Window Films DC37 Frosted Window Glass Film Installation Guide

Abode Window Films DC37 Frosted Window Glass Film

Specifications:

• Material: Static Cling Film
• Margin for Cutting: 0.5-1 inch on all sides
• Application Solution: Water with optional shampoo

Product Usage Instructions

Clean and Wet the Glass

• Thoroughly clean the window to ensure a dust-free surface.
• Generously spray water across the entire glass area.

Measure and Cut the Film

• Measure the Static Cling film, leaving an additional 0.5-1 margin on all sides for precise fitting.

Take off the Backing Film

• Peel off the backing film.
• Optionally, attach two pieces of Scotch Tape to a corner of the smooth side or directly adhere the film onto the glass.

Apply Water Generously on Film’s Static Side

• Spray the static side of the film generously with water.
• Consider adding 2-3 drops of shampoo to the water for enhanced adhesion.

Paste the Film on Glass

• Re-spray the glass before applying the film.
• Starting from the top, position the wet film on the window.
• Lightly spray water on the film.

Smooth Out Bubbles

• Secure the film by squeegeeing from the center to the edges, eliminating all water and air bubbles.
• Take your time to ensure a smooth and even application.

Trim Excess Edges

• Slowly trim any excess film, guided by the squeegee.
• Re-spray the film if needed. Repeat the squeegee process to perfect the application.

Seal and Dry

• Fold a cleaning cloth over the squeegee.
• Carefully remove any surplus water from both the film and the frame
  Please contact us at [email protected] if you encounter any problems during installation.

FAQ:

• Q: Can this window film be reused?
  A: The window film is designed for one-time use only. Reusing may affect its adhesion and appearance.
  Q: How long does it take for the film to fully adhere?
  A: The film typically fully adheres within 24-48 hours after installation, depending on environmental conditions.

Thank you for choosing our window film. Before you begin the installation process, please carefully review the following instructions.

Inside the plastic tube, you’ll find three complimentary tools provided to facilitate a smooth installation.

INSTALLATION

1. Clean and Wet the glass
   • Thoroughly clean the window to ensure a dust-free surface.
   • Generously spray water across the entire glass area.
2. Measure and Cut the Film:
   • Measure the Static Cling film, leaving an additional 0.5-1″ margin on all sides for precise fitting.
3. Take off the Backing Film:
   • Peel off the backing film. Optionally, attach two pieces of Scotch Tape to a corner of the smooth side or directly adhere the film onto the glass.
4. Apply Water Generously on Film’s Static Side:
   • Spray the static side of the film generously with water. The more application solution used, the better. Consider adding 2-3 drops of shampoo to the water for enhanced adhesion.
5. Paste the Film on Glass:
   • Re-spray the glass before applying the film.
   • Starting from the top, position the wet film on the window.
   • Lightly spray water on the film.
6. Smooth Out Bubbles:
   • Secure the film by squeegeeing from the center to the edges, eliminating all water and air bubbles. Take your time to ensure a smooth and even application.
7. Trim Excess Edges:
   • Slowly trim any excess film, guided by the squeegee. Re-spray the film if needed. Repeat the squeegee process to perfect the application.
8. Seal and Dry:
   • Fold a cleaning cloth over the squeegee.
   • Carefully remove any surplus water from both the film and the frame.

Please contact us to get the service if there are any problems. Our customer service email: [email protected]

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>