AKEZ BSJ Electric Scooter Owner’s Manual

June 1, 2024
AKEZ

AKEZ BSJ Electric Scooter

AKEZ-BSJ-Electric-Scooter-PRODUCT

Specifications

  • Model: BSJ
  • Motor: 48V/60V 600w Brushless motor
  • Charge time: 6-8 hours
  • Range per charge: 40-50km
  • Color: Red/Orange/Gray/Green
  • Climbing capacity: 15 degree
  • Size: 21509401000MM
  • Tyre: 3.00-10 tubeless with iron rim
  • Battery: 48V/60V 20ah lead acid battery
  • Max speed: 30km/h
  • Load weight: Not specified
  • Brake: Not specified

Product Usage Instructions

First Drive Operation

  1. Open the packing.
  2. Take out the key.
  3. Open the rear seat lock.
  4. Turn on the power off switch.
  5. Open the electric door lock.
  6. Check whether the meter light is on.
  7. Turn the speed gears switch back to gears 1 and R switch back to D, which is slow forward.

Maintenance

If the storage period is over 4 months, change the gear oil. We suggest using 85w-90 gear oil, but other gear oils are also fine. To change gear oil:

  1. Unscrew the screw at the bottom of the gear box to release the old gear oil.
  2. Screw the screw back in.
  3. Unscrew the screw on the top of the gear box to add the new gear oil.
  4. Screw the screw back in.

If necessary, charge the battery and check all items before driving. Try at low speed around a free traffic area.

Safety Precautions

  • Make slow acceleration when starting to avoid damage.
  • Avoid driving through rugged roads to prevent operation failure or body damage.
  • Inspect the scooter before driving.
  • Strictly abide by local traffic regulations and keep away from other vehicles during driving.
  • Avoid overloading the scooter.

Frequently Asked Questions

Q: How long does it take to charge the scooter?

A: The charge time for the scooter is between 6 to 8 hours.

Q: What is the recommended range per charge for this scooter?

A: The recommended range per charge is between 40 to 50 kilometers.

ATTENTION

The Driver and Passenger
This vehicle is designed only for one driver and one passenger.(Children under 12 are not allowed). Never exceed
to the Max load capacity of the vehicle.

Road surface
This kind of vehicle can drive on the flat road and the slope shall not be greater than 15 degree.

Please read the user manual carefully
You must pay attention to the sentence or paragraph with caution banner

Warning:
Not following the operation instruction in this manual may cause great damage to you.

Attention:
Not following the operation instruction in this manual may cause injury to both you and vehicle.
Regard this manual as a permanent parts, even when transfer the vehicle to other people transfer the manual at the same time

WARNING:

  • The electronics especially the controller need to be kept away from water, so be careful when you clean the vehicle.
  • Make slow acceleration when at start.
  • When the battery charger monitor shows under the yellow level, you must charge,or else it will bring damage to the battery.
  • Keep away from the charge socket,above 72v voltage will bring damage to your body.
  1. If you drive it at first time, please take training.
    Avoid blinding lights at night, you must drive on guard and pay attention to the road situation.

  2. .Non-fatigue driving vehicle

  3. Non-use of mobile phone during driving.

  4. Please adjust the seat before driving to reach the correct driving position.

  5. Be careful at road crossings, parking lot and driveway entrance.

  6. Speeding easily lead to an accident it should comply with the speed regulations never exceed the speed limit.

  7. Avoid driving through rugged road because the road may lead to operation failure or damage to body structures

  8. Before driving electric scooter the driver must first make inspections before.

  9. Keep away from other vehicle during driving strictly abide by local traffic regulations

  10. Please do not overload.

Scooter storage Storage

For long-term storage of the electric scooter for example in the winter time some steps need to be taken to
prevent malfunction and damage Besides before preparing storage also need to do part of the maintenance
work otherwise, once use the electric scooter, they tend to forget to carry out the maintenance.

  • Replace rear axle gear oil
  • Cover the electric scooter
  • Battery long time(more than a month),please be sure to take off from the electric vehicles,turn off power switch and the battery to the customs and state (after put the electricity, with the charger(3hours) and then placed in a cool and dry indoor storage(best temperature is 5°C~30°C), and every three months to charge 2 hours.

Reuse the electric scooter

  • Take off the electric scooter and clean it please replace the rear axle gear oil if the storage period is over 4 months.(and gear oil we suggest use85w-90,other gear oil also be fine)when you change gear oil,Unscrew the screw at the bottom of the gear box,release the old gear oil unscrew the screw back, unscrew the screw on the top of the gear box add the new gear oil, unscrew the screw back and you’re done
  • If necessary, charge at time and put on the battery.
  • Check all items before drive.Try at low speed around free traffic area.

Ⅳ. First drive operation

  1. Open the packing
  2. Take out the key
  3. Open the rear seat lock
  4. Turn on the power off switch
  5. Open the electric door lock
  6. Check whether the meter light is on
  7. Turn the speed gears switch back to gears 1and R switch back to D which is slow forward.

Specification

Model   BSJ Size   21509401000MM
Motor   48V/60V600w Brushless motor Tyre   3.00-10 tubeless

with iron rim
Charge time|  | 6-8 hours| Battery|  | 48V/60V20ah lead acid battery
Range per charge|  | 40-50km| Max speed|  | 30km/h
Color|  | Red/Orange/Gray/Green| Load weight|  | <200kg
Climbing capacity|  | 15 degree| Brake|  | Drum brake

DIMENSION

AKEZ-BSJ-Electric-Scooter-FIG-1

Parts diagrams

MODEL: BSJ

AKEZ-BSJ-Electric-Scooter-FIG-2

  1. Rear basket
  2. Rear wheel
  3. Foot brake
  4. Front wheel
  5. Front fender
  6. Front shock absorber
  7. Front basket
  8. Headlight
  9. Handle bar
  10. LCD Meter
  11. Front turn signal
  12. The armrest
  13. Backrest

AKEZ-BSJ-Electric-Scooter-FIG-3

  1. Taillight
  2. storage compartment
  3. Start key

HANDLEBAR DIAGRAM

AKEZ-BSJ-Electric-Scooter-FIG-4

CONTROLS & DISPLAY

AKEZ-BSJ-Electric-Scooter-FIG-5

  1. Headlight
  2. Battery power
  3. Speed
  4. Travelled distance

Ⅶ .Operation guide

Check before riding
Please check before riding to assure safety driving.

Battery power
Turn on the switch, watch battery meter indicator when it approaches the red mark position vehicle should be charged.

WARNING:
You should regularly check the tires and adjust tire pressure

 Check after the tire cooled
 You should regularly check whether there is a puncture on the tire especially tires leakage phenomenon which should repair immediately
 Check whether the tread cuts, whether embedded nails or other sharp objects. Check whether the rim indentation dent or deformation phenomena.
 When the tire tread wear to the tread wear limit mark it should be replaced with new tires.

WARNING:

 If the tire pressure sub-standard it will make the tire surface subjected to excessive wear and tear could cause a car accident. Tire pressure which is too low will cause tire slip or prolapsed wheels.
 It is dangerous to use great wear tire it will affect the adhesion between the tires and the road surface resulting in difficult driving on the accident or occurrence.

  1. Riding operation
    Preparation before driving: open the parking lock; put the key into the switch, turn it.
    Slowly accelerate the throttle when at start no throttle when decelerate
    WARNING:
    No operate throttle on-off rapidly otherwise the vehicle will rush out without control.

  2. Brake operation
    ontrol the throttle
    If you want to slow down please close the throttle and more important is to use two brake systems.
    WARNING:
    Drive on wet or loose surface road or in rainy days please be careful especially for operation of braking accelerating or turning.
    Simultaneous operation for front and rear brakes
    Attention: When driving down a steep slope please close the throttle completely, and use two brake systems to reduce the speed.
    WARNING:
    Don’t use single brake at high speed especially when you are on slippery road or turning corners. Use double brakes to avoid accident.

  3. Stop operation
    Turn the switch to stop the vehicle,and lock the parking lock.
    WARNING:
    Electric scooter should be parked on solidity, flat ground; otherwise it may cause injury or vehicle consequences of dumping.
    Security highlights

    • Lock the parking lock take away the key.
    • Power-off when leave.
    • Select high-quality alarm system.

Maintenance

The maintenance is important to electric scooter,if drive at high speed in a bad situation for a long time. must add the times of maintenance:If electric scooter have a big failure or have an accident must check for mainly spare parts.For example: frame,indicator parts and so on.Repair or change the worn parts to make sure safety.

Notice:
To ensure the electric vehicle safety and reliability do not allow the electric vehicles are modified. Use original parts or equivalent parts of similar quality during maintenance and replacement.If you use other parts of poor quality,it will affect the performance of electric vehicles and operating functions.

Warning:
To ensure the safety of personnel from harm regardless of any program of maintenance work, be sure to turn the power off parked the car on a flat hard surface.

Attention:
If you store your vehicle more than a month’s time or to stop using in the winter period it is required to make maintenance work to bad tires batteries. etc., aging and corrosion.
Often driving on uneven roads in order to hold the good performance of your vehicle,it must be maintained.

Maintenance for battery

If the vehicle will not use for a long time, please take out the battery, full charge and store it in a cool, well ventilated and dry place
If the head of battery was corroded, please take out the battery and clean it .
Turn off the ignition switch before take out the battery take apart the negative pole first.
When you assemble the battery fix the positive pole first then the negative pole. don’t mix.

  1. Discharge with large current is negative to the battery

    • When the electric tricycle is in startup, headwind, uphill and heavy loading, the discharge current of the battery
    • will be large. When the charging is insufficient, the life of the battery will be shortened.
    • The vehicle should be charged after driving in time. The battery cannot be stored with capacity loss. Even the vehicle is not used for a long time, it must be charged once a month.
  2. When the ambient temperature is more than 40℃ or less than – 10℃, the life of the battery will be shortened.
    Therefore, in summer, due to the hot weather, the direct sunlight should be avoided for the battery. And in winter, due to the coldness, the battery should be stored and charged indoors. And after the battery is fully charged, the charging should be extended for 2- 3h.

  3. When the ambient temperature is -10℃, the power capacity of the battery is only 60%, so every mileage under full charging in winter is less that that in summer.

  4. Batteries are consumables and the life of the battery is limited.

Troubleshooting

Malfunction Possible Cause Solution






Vehicles can’t drive

| The key is on OFF position or FOREBACK switch is on middle neutral| Turn the key to ON position or choose FORE BACK switch
Battery without electricity| Charge it
Battery terminal electrode corrosion or loose| Cleaning corroded areas, tighten the nut links
Key switch wire loose or damaged Connect the wire| Repair the key switch
Accelerator switch damage| Change the switch
Power switch is not on| Tun on the power
Motor malfunction| Repair or replace
The parking lock not unlock| Grip the rear brake handle bar to unlock it
Speed instability| Accelerator malfunction| Change the accelerator


Abnormal sound on motor

| Motor shaft malfunction| Change the shaft
Motor damage| Repair or replace it



The battery can’t be charged

| Charger damage| Check the charger, repair or replace it
Poor contact for charge| Check the plug
Battery damage| Check battery
Battery excessive discharge| Check or change battery
Uneven tire wear| Tire pressure is too low| Inflated to the recommended pressure value




Steering is not flexible, the swinging direction

| Steering column bearing lubricant solidification| Inject some lubricating oil
Hinge lose all moving parts Lubricants| Fill with oil all moving parts
Wear steel bowl| Change the steel bowl
Uneven tire inflation pressure| Adjust the inflation pressure
Steering column lock nut loose| Tighten the lock nut
Wheel swing| Repair or replace the shaft, front axle
Rim screw loose| Tighten the screw


Brake steer

| Uneven tire inflation pressure| Adjust the tire inflation pressure
Wheel braking force is uneven| Adjust the tie shoe



Brake force not enough

| Brake shoe severe wear| Change the brake shoe
Brake pipeline leak, brake fluid is not enough| After the exhaust pipe joints screwed tight, add

hydraulic fluid

Brake shoe and brake disc with oil or water| Clean


Vehicle drive or stop by time

| Circuit erercurent and overtemperature protection system does not start| Replace the controller
Circuit connector is loose| Fastening tabs and connected wires


Vehicle stop at start

| Low power| Charge the battery
Drive motor damage| Inspection, repair

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals