Lights4Less GWUF6030-S Surface Mounted LED Spitfire Instruction Manual
- June 1, 2024
- Lights4Less
Table of Contents
Lights4Less GWUF6030-S Surface Mounted LED Spitfire
Important
It is illegal for anyone, except for a licensed electrician to install or maintain this product. Before installation, ensure that the electricity supply has been switched off and isolated. Installation must be carried out in accordance with the relevant Australian and International Standards.
Specification
Operating Supply : 220-240V / 50-60Hz
Compliance : AS 2293
Mounting : Surface Mount
Classification : D40
Installation
- Disconnect mains supply prior to wiring.
- Unscrew from side to seperate the back plate and surface mounted ufofire.
- Fix the back plate to the ceiling.
- Connect with cable.
- Re-attach surface mounted ufofire and back plate.
- Remove screws to separate the back plate
- Fix the Plate to the ceiling.
- Re-attached the bracket to the fitting and tighten screws.
Note
For first usage, power ON the unit for 24 hours to fully charge the battery. Interrupting the mains supply will discharge the battery.
Testing
The emergency lamp must illuminate for at least 90mins after disconnection from the mains. Press and hold Test Button or switch Off Mains Supply, check the emergency lamp is ON. Release the Test Button or Switch On Mains Supply, check the normal lamp is OFF (NON-Maintained operation).
Self-Testing
Every one month, the unit will discharge itself for 3s-180s.
If the main power supply does not switch off for 12 months, the unit will
discharge itself until out of battery, then will charge again.
Warranty
Products have 3 years (from date of purchase) replacement warranty including
battery.
Products have to be connected to permanent live power otherwise warranty will
be void.
Must be installed by licensed electrician.
This warranty does not cover loss or damage by misuse, incorrect installation,
incorrect voltage or nonauthorized electrical connections, adverse external
conditions (such as power surges and dips, exposure to heat, corrosion etc).
Products that have been altered in any way or used other than in accordance
with instruction are not covered by this warranty.
Must be installed by a licensed electrician
Documents / Resources
|
Lights4Less GWUF6030-S Surface Mounted LED
Spitfire
[pdf] Instruction Manual
GWUF6030-S Surface Mounted LED Spitfire, GWUF6030-S, Surface Mounted LED
Spitfire, Mounted LED Spitfire, LED Spitfire, Spitfire
---|---