City Life CL7000 Inox Freestanding Bath Filler Instruction Manual
- June 1, 2024
- City Life
Table of Contents
City Life CL7000 Inox Freestanding Bath Filler
Product Information
Specifications
- Operating Static Pressure: 150 – 500kpa
- Maximum Hot Water Temperature: 75 degrees
Frequently Asked Questions
- Q: Can this product be used for gravity feed application?
- A: No, this product is not suitable for gravity feed application. It should comply with AS/NZS3500.1 2003 or relevant local requirements.
- Q: What should I do if the water pressure exceeds the recommended range?
- A: If the water pressure exceeds 500kpa, you must install an approved pressure limiting valve to regulate the pressure.
IMPORTANT!
- Please read this instruction Prior to installation
Installation Instructions
Installation
- Ensure both supply pipes has been flushed and is free from debris before proceeding.
- When installing into a concrete floor, a chase will need to be cut out of the concrete to rough in the supply pipe. Rough in to a spout outlet with a 1/2 inch male BSP thread & cap until fit-off.
- Feed the two flexible hoses through the floor bracket, riser pipe & cover plate. Hand tighten riser pipe into the bracket & slide plate onto riser pipe.
- Connect the two flexible hoses into the mixer by hand tightening & making a final adjustment with spanner. Hand tighten riser pipe onto mixer.
- Connect the two flexible hoses into the water supply by hand tightening & making a final adjustment with a spanner.
- Screw mounting bracket to floor using fixings provided. Slide cover plate down into position.
Care And Use
- Shutting the tap gently will reduce the chance of water hammer or ‘banging’ pipes.
- Regularly clean the chrome surfaces only with non scouring, neutral wash solutions.
Parts
IMPORTANT RECOMMENDATIONS FOR INSTALLATION
Installation should comply to AS/NZS3500.1 2003 or relevant local requirement.
Not suitable for gravity feed application.
Hot & cold water inlet pressures should be equal.
WATER PRESSURE
- Operating static pressure is 150 – 500kpa. If pressure exceeds this, then an approved pressure limiting valve must be installed.
PRE-FLUSH
- Always flush out the pipework before connecting any faucets.
- Damage caused to the faucet by debris coming through the pipework is not covered under warranty.
WATER TEMPERATURE
- Maximum hot water temperature is 75 degrees.
ATTENTION!
- Failure to do so will void the warranty.
Contact
- T 1300 837 688
- E info@verotti.com
- www.verotti.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>