tp-link S500 Smart Wi-Fi Light Switch User Guide
- June 1, 2024
- tp-link
Table of Contents
tp-link S500 Smart Wi-Fi Light Switch User Guide
©2023 TP-Link 7106510808 REV2.0.0
*Images may differ from your actual product
Wire Your Switch
- Turn off the circuit breaker. Check whether your power is off by turning your switch on and off a few times.
CAUTION !
- Risk of Electric Shock – The product should be installed by a qualified electrician.
- High Voltage – Disconnect power supply at the circuit breaker before servicing.
- Use copper conductors only.
- Remove the wallplate of the old switch and label the wires.
Ground : Usually green or copper.
Neutral : Usually white, not connected to the dumb switch.
Line/Load : Usually black, and connected to the dumb switch.
If you are unsure, consult a qualified electrician.
-
Disconnect wires from the old switch.
-
Connect the wires to the smart switch as shown below.
Note: No need to distinguish between Line and Load wires.
- Line up the switch with the mounting holes. Secure it with screws.
Set Up Your Switch
STEP 1 DOWNLOAD APP
Get the Tapo app from the App Store or Google Play.
STEP 2 SET UP
Tap the button in the app. Select Switches and then your model. Follow the step-by-step app instructions to set up your smart switch.
Third-Party Services
Tapo works with Alexa, Google Assistant, and other third-party services to
control your switch by voice. Go to Me > Third-Party Services in the Tapo
app to integrate third-party services.
For step-by-step setup instructions, please visit:
-
Google Home Assistant:
https://www.tp-link.com/support/faq/1534/ -
Amazon Alexa:
https://www.tp-link.com/support/faq/944/
Specifications
Rating: 100-120 V~ 50/60 Hz
Load: 15 A General Use
600 W Max Incandescent, 1/6HP Motor
Operation temperature: 0~40℃
Method of mounting included: Independently
mounted (Vertically position only);
Operating control, Type 1.C action
Pollution Degree 2, Rated Impulse Voltage 2500V
Software Class A, NEMA Type 1
Recommended Load Types:
LED: ≤ 100W Ceiling Fan: ≤ 120 W
Appearance
Button Explanations
LED Status
CAUTION
High Voltage-Disconnect power supply at the circuit breaker before servicing
Safety Notice
Before installing, servicing or removing the switch, read and follow all safety precautions including the following:
- CAUTION – Risk of Electric Shock – More than one disconnect switch may be required to de-energize the equipment before servicing. A circuit breaker which disconnects the Line and Neutral conductor simultaneously is suitable. Ensure power is off at the circuit breaker before removing or installing any switch. Use a non-contact voltage tester to ensure the power is off.
- The Smart Switch must be installed and used in accordance with the National Electric Code (NEC) or your local electrical code. If you are unfamiliar with these codes and requirements, or are uncomfortable performing the installation, consult a qualified electrician.
- Do not install the Smart Switch with wet hands or when standing on wet or damp surfaces.
- Install only in a suitable UL Listed outlet box (suitable dimensions:
H > 2.95 in./75 mm, W > 1.81 in./46 mm, D > 2 in./51 mm).
Need some help?
Visitwww.tapo.com/support/
for technical support, user guides, FAQs,
warranty and more information.
References
- How to connect my Tapo / Kasa smart device to Google Home | TP-Link
- How to Link a Tapo or Kasa Account to Amazon Alexa | TP-Link
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>