ethereal CS-HDMARC1 HDMI ARC Audio Extender User Guide
- June 2, 2024
- Ethereal
Table of Contents
ethereal CS-HDMARC1 HDMI ARC Audio Extender
What’s included
Ports and Interfaces
-
POWER: USB-C DC 5V Power In
-
UTP OUT: Connect to RJ45 OUT via CAT5E/CAT6 Cable
-
STATUS: Status LED Indicator
On: The Sender is working properly but the connection between the Sender and receiver is not successful
Blinking: The Sender is working properly, and the connection between the Sender and receiver is successful
Off: The Sender is not working properly -
SPDIF IN: Connect to Input Audio Sources via Optical cable
-
ARC IN: Connect to HDMI ARC Port of TV via HDMI cable
-
SPDIF/ARC: Switch the Button at the ‘SPDIF or ARC’ Side for Needed Port Working
-
UTP IN: Connect to RJ45 IN via CATE/CAT6 Cable
-
SPDIF OUT: Connect to Output Audio Sources via Optical cable
-
ARC OUT: Connect to HDMI Port of AMP via HDMI cable
Connection Diagram
Introduction
The product is an extender for both HDMI ARC and SPDIF audio pass-through, It supports CEC pass-through between HDMI ARC input port and ARC output port to handshake for ARC For TVs that don’t support HDMI ARC capabilities, the extender provides an independent SPDIF audio pass-through channel SPDIF audio can be transmitted from the SPDIF IN port of the Sender to the SPDIF OUT port of the receiver.
Features
- Cost-effective solution for extending the digital S/PDIF or HDMI ARC audio through using single low-cost Cate or Cat6 cable for up to 150 meters (492feet) away from the source.
- Supports PCM, DTS and Dolby Digital audio format.
- High performance, zero signal loss
- Supports CEC pass-through between HDMI ARC Input port and ARC Output port to handshake for ARC transmission
- Supports Dual digital audio inputs: 1 x SPDIF and 1 x HDMI ARC
- Supports Dual digital audio outputs: 1 x SPDIF and 1 x HDMI ARC can output each signal separately
- Easy to customize the cable length as needed. No need to have digital audio cables prefabricated.
Note: To set the extender to arc or SPDIF mode, users need to set the dip switches of the Sender and receiver to the same position. For example,when the extender is set to ARC mode. the dip switches of Sender and receiver both need to be switched to the ARC position.
Specification
TROUBLESHOOTING
EtherealPro.com
386-255-0234
460 Walker Street
Holly Hill, FL 32117-2653
©2023 Ethereal
Designed and Manufactured to Ethereal’s Specifications
MADE IN CHINA
Dolby is a trademark of Dolby Laboratories.
All other trademarks, registered trademarks, or service marks are the property
of their respective owners.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>